Road Transport Safety Checklist for Farm Equipment
Most farm equipment crashes on public roads involve a car that closed on a slow machine faster than the driver expected, or a machine that was wider, taller or longer than the driver of the car realized. A good road routine starts in the yard, with a short walk-around, and carries on with how the machine is driven.
The walk-around before pulling out
Do this every time, even for a half-mile trip.
- Hitch and pin. The drawbar pin should be the correct pin with its retainer in place. Safety chains go on and cross under the tongue, with enough slack to turn but not drag. Details are in the implement hitch safety chain inspection guide.
- Lights and marking. Clean the lenses and test the flashers, turn signals and brake lights with a helper standing back. The slow-moving vehicle emblem must be present, clean, upright and not faded. See the lighting and SMV emblem inspection form.
- Tires. Look at the sidewalls and check inflation cold against the manual. Wagons and implements often get ignored here.
- Brakes. On tractors with locking pedals, lock them together before road speed. Test the brakes in the yard first, pulling the load.
- Transport locks. Folded wings, raised marker booms and lift arms should be latched and pinned. Hydraulic cylinders should not be the only thing holding a wing up.
- Loose items. Walk off every tool, strap and chain that might fly off.
Reading the road ahead
Know the route in advance. Note low wires, narrow bridges, soft shoulders, and railroad crossings. Measure how wide the machine is in transport position and compare it to the roads. State agencies publish width, length and lighting rules for farm equipment, and these differ by state. Check with your state department of transportation or Extension office rather than assuming, and see FMCSA for federal guidance on commercial vehicles.
How experienced operators drive
Move in daylight when possible, and avoid the times when the sun is low behind you or in oncoming drivers' eyes. Keep a speed that the slowest piece in the train can safely handle, including the stopping distance of a loaded wagon. Never exceed the speed rating on the implement tires or on the hitch for towed machines per the manual. Pull over at safe wide spots to let traffic clear.
Turn signals do not mean much to a car approaching fast, so signal early and take wide turns carefully. Never allow riders on drawbars, fenders or implements. Keep both hands ready on the wheel and avoid distractions.
Make sure the load on a trailer is secure; the equipment transport tie-down checklist covers that part.
When to stop and fix
If a light is out, if the SMV emblem is missing, if brakes pull to one side, or a tire shows cord, park it. Replace safety-critical items such as brake parts, hitch pins and chains with new parts instead of used, and keep spare bulbs, fuses and pins in the tractor toolbox so a small fix does not become a reason to run without lights. For more on road safety training, see NIOSH agriculture.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: FMCSA · NIOSH Agriculture · NHTSA