Implement Hitch & Safety Chain Inspection
When a towed implement comes loose on a road, it is not a breakdown, it is a crash waiting to happen. The hitch and the safety chain exist for exactly that moment, and they only work if they are in good shape and used correctly.
Start at the tractor drawbar
Look at the drawbar for cracks, bends, and elongated pin holes. A hole that has worn oval lets the hitch pin rattle, and the shock loads wear it faster. Check that the drawbar is pinned in the position the manual calls for, and that the hitch height lets the implement tow level. Never hook a load to the axle or any point other than the drawbar and designed hitch points, because that is how tractors flip over backward.
The hitch pin, clevis, and tongue
Pins should fit snugly and be the correct type and grade. Look for bent pins, deep grooves, and worn lock clips. A bolt or nail in place of a proper pin is a common and dangerous shortcut. Check the clevis or hitch eye on the implement for cracks, wear at the contact points, and weld repairs that look rough. Wear that has taken a noticeable portion of the thickness means the part should be replaced; the manufacturer's manual or parts catalog gives limits.
For trailers and wagons with a tongue jack, check that the jack works and the tongue is not bent. See the farm truck pre-trip inspection for the vehicle side of road travel.
Safety chains
The safety chain is a backup, not the hitch. It should be rated for the weight of the implement, attached to the tractor frame or the designated chain point, and crossed or looped as the manufacturer intends so that it catches the tongue if the hitch fails. Leave only enough slack for turning. Look at each link for stretching, cracks, nicks, and rust, and look at the hooks and latches for spring tension. A chain that has been shock-loaded or that shows bent links should be replaced, not repaired with a bolt. Do not use a chain that you cannot confirm the rating on.
Hitch components, chains, and pins are safety-critical. Buy new parts that match the catalog rating instead of pulling them from a salvage pile unless you can confirm the rating and condition, and when in doubt, buy new.
Before you leave the yard
- Pin and clip in place.
- Chain connected.
- Lights, SMV emblem, and brakes working; see the lighting and SMV emblem inspection form.
- Jack raised or stowed.
Road rules vary by state, so check with your state agency or the FMCSA for requirements instead of assuming. Your local dealer can help confirm the right replacement parts.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: FMCSA · OSHA Agriculture · NHTSA