Parts & Salvage Directory

Equipment Transport Tie-Down Checklist

A machine that shifts on a trailer can cause a crash, wreck the equipment, or kill the people in the next lane. Tie-down is not complicated, but it is easy to rush. These steps follow the way experienced haulers do it.

Before the machine goes on

Check the trailer first. Look at the deck for rot or cracks, the ramps for secure attachment, the hitch, safety chains, brakes and lights. If the trailer has a weak deck or a tired winch, the best chains in the world will not help. The trailer floor and ramp inspection covers what to look for.

Confirm the load is within the trailer's and the tow vehicle's ratings, which are on the plates and in the manuals. Do not guess at weights. Look up the machine weight in its manual, and add attachments.

Loading and position

Drive on slowly and straight, in low gear, with no one standing near the ramps. Position the machine so that weight sits ahead of the trailer axles, typically with a bit more weight toward the front so the tongue carries some load. A tail-heavy load can make the trailer sway badly. Lower buckets, forks and blades to the deck, set the parking brake, shut off the engine and take the key.

Fold or secure anything that sticks out. Turn off the fuel valve if the machine has one, and lock articulated steering or booms if the machine has a transport lock.

Securing it

Use chains or straps and binders rated for the job, and pull the working load rating from the tag or manual rather than assuming. Attach to the designated tie-down points on the machine, not to axles, hoses, lights or the loader frame unless the manual allows it. Run chains in a pattern that stops the machine from moving forward, back and sideways. Many haulers use four points, one at each corner, angled out and down.

Keep chains from rubbing on sharp edges. Use edge protection or sleeves when needed. Tighten binders until the machine is firmly held, and tie off the loose binder handles so they cannot vibrate open.

On the road

  1. Stop after the first few miles and recheck chains and binders. Loads settle.
  2. Check again at each fuel stop or rest break.
  3. Make sure tarps and loose parts are not flapping. Cover lights and plates.
  4. Drive slower than you would unloaded, give extra stopping distance, and take corners wide.

Check height, width and weight rules, along with lighting and flag requirements, with your state transportation office and the FMCSA. Rules vary and are not something to guess at. See the road transport safety checklist for what applies on public roads.

Common mistakes

  • Using worn, kinked or chain with stretched links
  • Chaining over a hydraulic hose or a tire
  • Skipping the recheck
  • Leaving the loader arms up, which raises height and weight above the axle

Replace damaged chains, straps and binders with new ones. Do not buy used tie-down gear from a salvage pile, because the rating and wear history are unknown. Dollar-for-dollar, it is the cheapest safety purchase on the farm.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: FMCSA · NHTSA · OSHA Agriculture