Farm Equipment Fire Prevention Checklist
Equipment fires have a short list of causes, and most are preventable with housekeeping. Dry crops, dust, hot exhausts, friction and fuel all gather in the same few places on a machine. Know those places and clean them before each shift.
Where fires start
Look at these every time, but especially in dry, dusty or windy conditions:
- Around the exhaust and turbocharger. Chaff, straw and leaked oil collecting on hot metal will ignite. On combines, check the engine compartment and the area around the exhaust daily.
- Bearings and belts. A failing bearing runs hot, and a slipping belt can spark or glow. Listen for squealing and watch for burning smells. Hot bearings often show up first as a smell or smoke from a driven part. Hay equipment and the baler knotter area collect dust and need regular cleaning.
- Hydraulic hoses and fittings. A pinhole leak sprays mist onto hot surfaces. Replace hoses that are cracked, rubbing or weeping, using the correct part from your parts catalog.
- Wiring. Chafed insulation, loose terminals and amateur splices cause shorts. Repair wiring properly, with the right connectors, and fuse correctly.
- Batteries and charging systems. Corroded terminals and bad connections generate heat. Keep them clean and tight.
A routine that works
- Blow off or brush down the engine bay, radiator screens and belts at the start of the day, with the engine off and cool.
- Check for fresh oil, fuel or hydraulic fluid under the machine, and fix leaks before running.
- Check bearings by touch, carefully, or with a heat-sensing tool, after the first hour. Be cautious around moving parts.
- Make sure the extinguisher is mounted and charged. See the extinguisher placement and inspection log.
- Before leaving the field, look the machine over again. Smoldering material may not show for a while after you shut down.
Do not use compressed air near open flame or in a way that blows debris into sensitive parts. Wear eye and hearing protection.
Fueling and hot work
Shut the engine off and let it cool before fueling. Keep fuel off hot parts, and do not smoke nearby. Use approved containers. Never fuel a running machine.
Welding, cutting and grinding throw sparks that can travel. Clear dry material from the area, keep an extinguisher within arm's reach, and watch the spot for a while afterward. Take care repairing a fuel tank or anything that held fuel, and do not weld on a container that had flammable material in it unless a qualified person has made it safe. The welder safety checklist has more.
Parking and storage
Park machines away from buildings when they have just run hot, and out of dry grass. Wash off crop residue before storing, since stored chaff and mice nests are fuel. Disconnect the battery for long-term storage if the manual recommends it.
Learn from near misses
If you find a hot spot, a smoking bearing or a smoldering patch, write down what it was and fix the cause. Local fire departments, Extension and NFPA offer material specific to ag fires. Combine seasons run long, and a few minutes of cleaning at lunch costs far less than a lost machine.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: NFPA · OSHA Agriculture · CDC NIOSH Agriculture