Parts & Salvage Directory

Baler Knotter Troubleshooting Guide

The knotter is the most hated part of a square baler, and the most misunderstood. Most missed knots are not mysterious. They come from twine, tension or worn parts, and the symptom tells you where to look.

Start with the twine

Before touching a knotter, look at the twine. Use the type the baler maker calls for, store it dry and out of sun, and make sure it feeds from the can without snagging. Cheap or weak twine, or twine that is wet, can cause trouble no adjustment will fix. Check the twine path from can to needle for burrs, sharp edges and worn eyelets, because a nick in a guide can fray twine at the worst moment.

Reading the symptom

No knot, twine just cut. The billhook may not be turning, or the twine is slipping out of the twine disk. Look at the disk for wear and for hay chaff packed in the notches. Check the tension on the disk holder against the manual.

Knot forms but slides off. That often means a worn billhook, a weak billhook spring or a worn knife. Watch the hook as it rotates. If the jaws do not close firmly on the twine, the hook or its spring is tired.

Long tails on the knot. The twine knife may be dull or out of position, or the stripper may be worn. A stiff or sticky stripper arm cannot clear the loop.

Knots only miss on one side. Compare the two knotters. A knotter that works while its neighbor does not tells you which one has a worn part. Swap a known good part across and see if the problem moves.

Needles miss the knotter. That is a timing and alignment issue and sometimes a bent needle. Do not force it, and do not adjust timing without the manual.

Safety and where the line is

Knotter work happens near needles that can swing and a plunger that can cycle. Shut the baler off, remove the key, disengage and secure the PTO and wait for all motion to stop. Block the plunger if the manual says to. Never reach into the knotter area with the machine running or before the flywheel has stopped. The OSHA lockout/tagout guidance is a good refresher.

Leave the major timing adjustments, including needle timing and flywheel position, to a dealer or someone with the timing procedure in front of them. Getting it wrong can bend needles and damage the drive. If a clean, dry baler with new twine still misses knots, that is the time to call.

Parts, records and spares

Keep a small kit of knotter wear parts in the tool box: billhook, twine disk, knife and stripper. Write down the model and serial number of the baler, since knotter parts differ by model and year. Used knotter parts are a gamble because wear is hard to judge. Buy the small wear parts new, and consider salvage only for castings and frames. To find a dealer or salvage yard, use the state directory.

Before baling starts, review the square baler maintenance log and the hay harvest equipment checklist. Time spent on these in the shop saves hours of hay on the ground.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Lockout/Tagout · Extension.org