Welder Safety & Maintenance Checklist
A farm welder gets used for everything from patching a bucket to rebuilding a gate, and it is often set up in a hurry between other jobs. That hurry is where most of the trouble starts. A tidy, well-kept welder is safer to run and makes better welds, so it is worth a few minutes before each project.
Look at the cables and ground before the arc
Start by checking the cables from end to end. Cracked insulation, cuts, and copper showing through are all reasons to retire or repair a cable, because a bare spot can arc to a metal bench or to you. Check the electrode holder or MIG gun for burned or loose connections. A connector that feels warm to the touch after a short weld is carrying resistance and wasting power.
The work clamp matters more than most people think. Clamp it to clean, bare metal as close to the weld as you can, not to a tractor part that goes through bearings. Welding current that finds its way through a wheel bearing, a hydraulic cylinder rod or a chain can pit the metal inside. Before welding on any machine, disconnect the battery and the alternator leads, and keep the current path short.
Fire and fumes
Sparks travel farther than expected. Clear the area of hay, oily rags, paper, sawdust and fuel containers, and keep a charged extinguisher within reach. Watch for fumes from fuel tanks, drums and hydraulic parts: never weld on a container that has held fuel, solvent or anything flammable unless it has been properly cleaned and made safe by someone qualified. After you finish, look around again 30 minutes later for smoldering material. This is also why the farm equipment fire prevention checklist belongs near the welding bench.
Welding fumes from galvanized, painted or coated steel can be harmful. Weld outside or with strong ventilation, and keep your head out of the plume. The workshop ventilation checklist explains how to set up airflow in a farm shop. Wear a proper helmet with the shade the welder's manual recommends, leather gloves, a flame-resistant jacket and boots with covered tops. Flash burns to the eyes can feel like sand in the eyes hours after the weld.
Machine upkeep
With the machine unplugged, blow dust out of the case with dry, low-pressure air, because dust and metal grit collect inside and cause shorts. Look at power cords, plugs and breaker size, and run the welder only on the circuit and extension cord the manufacturer calls for. For engine-driven welders, follow the engine's oil and filter schedule in the manual.
On a wire-feed machine, the wear parts are the contact tip, nozzle, liner, drive rolls and gas hose. Signs of trouble include wire that stutters, burns back into the tip, tangles at the drive rolls or gives a rough, spattery arc. Replace the tip and clean the liner before blaming the machine. Check gas cylinders: chained upright, cap on when moving, and regulator and hoses free of cracks or leaks.
Buying parts
Cables, clamps, nozzles and tips are low cost and best bought new. A used welder or a salvage regulator can be a fair deal if it has been checked, but never use a gas regulator or hose with damage or unknown history. Note the make, model and serial number when you order.
For legal requirements on hot work and shop safety, consult OSHA and your insurer rather than relying on a general guide.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Agriculture · NFPA · CDC NIOSH Agriculture