Trailer Light & Brake Inspection Form
Most trailer trouble on the road traces back to one of two things: a connector that corroded over the winter, or a brake that nobody looked at since last season. Both can be found in ten minutes in the yard, and both are far cheaper to fix there than on the shoulder of a highway.
Lights first, with a helper
Hook up to the truck and run through every function while a second person stands behind: running lights, left and right turn signals, brake lights, and hazards. Do not trust a single glance in a mirror. Watch for a light that flickers when the trailer is tapped or the wire is wiggled, because that points to a loose ground or a broken conductor inside the insulation.
Bad grounds cause more lighting complaints than bad bulbs. If lights dim when another one is turned on, or work only when the trailer sits at a certain angle, clean the ground connection to the frame down to bright metal and refasten it. Check the plug on the truck and the plug on the trailer for green or white corrosion, bent pins and cracked housings. Plug and socket styles vary, so match the replacement to what the trailer and truck already use rather than guessing.
Lenses and reflective tape count too. Cracked lenses let water in, and water in a lamp socket soon becomes a dead light. Faded or missing reflective tape should be replaced so the trailer can be seen at night. If the trailer carries a slow-moving vehicle emblem, the lighting and SMV emblem inspection form covers that side.
Brakes by symptom
Pay attention to how the trailer behaves, because brakes tell on themselves:
- Trailer pushes the truck when you slow down: brakes may not be working at all, or the brake controller is set too low.
- One wheel hub is much hotter than the other after a trip: that brake is dragging or a bearing is failing.
- A grinding or squealing noise when stopping: linings may be worn to the rivets, or a drum may be scored.
- Pulling to one side under braking: uneven brake action, often a bad magnet or a contaminated lining on one side.
Electric brakes depend on wiring, magnets and the controller in the cab. Hydraulic surge brakes depend on fluid and the actuator at the tongue. Adjustment procedures differ by axle brand, so follow the axle maker's manual and see the brake adjustment log for trailers for how to track the work. Do not guess at adjustment on brakes you have not been shown how to service.
Breakaway system
If the trailer has a breakaway switch and battery, test it as the manufacturer describes. Pulling the pin should lock the trailer brakes on. A dead breakaway battery is a very common hidden defect, and the cable must be attached to the truck frame or hitch support, never to the same ball or chain that holds the trailer on. Replace a battery that does not hold charge.
Wheel ends and tires
While the wheels are off the ground for a brake check, spin each one by hand. Roughness, a click or side-to-side wobble means a bearing needs attention. Look at the tires for cracking, bulges and uneven wear, and check pressure cold against the placard or the tire sidewall limit.
New or salvage parts
Brake drums, backing plates and axle components from a salvage yard can look good, but brake linings, magnets, wheel cylinders, hoses and breakaway units are safety-critical and best bought new. Wiring harnesses and some connectors are fine to replace with matching parts. Whatever you buy, record the axle brand and capacity from the tag so the right parts come across the counter. For wider rules on trailer equipment and inspections, see NHTSA and the FMCSA.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: NHTSA · FMCSA · OSHA Agriculture