Brake Adjustment Log for Trailers
A loaded farm trailer can push a truck down a hill if the brakes are not up to the load. Trailer brakes are one of the few systems that are easy to neglect because you only notice them in a hard stop. A regular log makes the neglect visible.
What to check and in what order
Jack up and support each axle on stands, never on a jack alone. Spin each wheel by hand. The wheel should turn freely with a faint rub at most, and with no grinding, ticking or heavy drag. Rock the tire at the top and bottom to feel for play in the bearing. Play means the bearing needs attention, and the wheel bearing repack record explains how to handle it.
With the wheel off or the dust cover open, look at the drum or rotor. Look for deep scoring, heat-blue patches, and cracks. Check the lining or pads for thickness against the manufacturer's minimum, and for oil or grease contamination. A greasy lining will not hold, and a leaking hub seal is the likely cause.
For electric brakes, look at the magnet face and the wiring. For hydraulic surge brakes, look at the master cylinder, the fluid level and the lines for rust and kinks. For air brakes on heavy trailers, drain moisture from tanks and look at the slack adjusters, but air brake service is better left to someone trained.
Adjustment and testing
Adjustment follows the manual for your axle brand. Most brake types have a star wheel or an adjusting cam. Typically the process takes the shoes out until they just drag, then backs off slightly. Do not invent your own procedure. After adjusting, test the controller output and the response with the trailer coupled to the truck, at low speed in a safe space. A trailer that pulls to one side has uneven braking, and one that locks up is over-adjusted or underloaded relative to the brake setting.
Also test the breakaway switch and the battery that powers it. The pin should pull cleanly, apply the brakes, and the battery should hold a charge. Check the lights as well, with the trailer light and brake inspection form as a guide.
Keeping a useful record
Log the date, the trailer, the axle make and the part numbers on the label. Add what you saw: lining thickness, play, drag and the date you adjusted or replaced anything. Over a few seasons the log shows which axle wears faster, which usually hints at an alignment or load problem rather than bad luck.
Parts: do not gamble here
Brake shoes, pads, drums, magnets, lines, hoses and controllers should be bought new and matched to the axle rating and the label. A salvage axle can be a reasonable buy only if every brake part on it is replaced and the axle is confirmed straight and to the right rating. For local suppliers, use the state directory. Rules on trailer brakes vary, so check with your state agency or the FMCSA rather than relying on rules of thumb.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.