Parts & Salvage Directory

Tractor Daily Pre-Operation Inspection Checklist

Five minutes with a tractor before you turn the key will find most of what is about to go wrong. The trick is to do it the same way every time, so your eyes learn what normal looks like. Start at the front left and walk clockwise, and finish in the seat.

The walk-around

Look under the tractor first. A fresh wet spot on the ground, or a stain that was not there yesterday, tells you which system to look at. Dark oil points to the engine or the transmission, red or amber fluid to hydraulics, green or orange to coolant. Then look at the front: radiator screen free of chaff, no wrapped twine on the front axle or wheel hubs, tires with no bulges or cuts in the sidewall.

Along each side, check the lights and the slow-moving vehicle emblem if you will be on the road; the lighting and SMV emblem inspection form goes into that. Look at the hitch and drawbar pin, and the keeper on every pin. Check the PTO shield is in place and turns freely, and the master shield is not cracked.

Fluids and filters

With the tractor level and the engine cold, pull the engine dipstick, check the coolant in the recovery bottle (never open a hot radiator cap), and check the hydraulic or transmission level as the manual says. Look at the air cleaner restriction indicator if one is fitted. Check the fuel level and drain any water from the fuel filter bowl if yours has one.

In the seat

Adjust the seat and put on the seat belt if the tractor has a ROPS; the ROPS and seatbelt compliance checklist explains why. Test the brake pedals: they should be latched together for road use and should hold evenly. Turn the key and watch the gauges. Oil pressure should rise at once. Listen for knocks, a squeal from a belt, or a whine from the hydraulics. Cycle the loader or hitch once and watch for slow movement or jerking.

Stop and fix it if you see

  • Fluid pouring or dripping steadily from any line.
  • Brakes that pull to one side or have a low, soft pedal.
  • A cracked or missing guard or shield.
  • A seat belt that will not latch, or ROPS bolts missing.
  • Tires with exposed cord, or a loose wheel nut.

These are not "finish the job and look at it later" problems. Brakes, steering and shields are safety-critical, and parts for them should be bought new rather than salvaged. A little oil use is common, but sudden changes in oil level or hydraulic fluid mean a leak you have not found.

Keep a small stock

A shelf with a spare lamp or two, fuses, hydraulic couplers, a spare hose clamp, a grease gun, extra pins and keepers, and the filters for your tractor makes down days shorter. Note the part numbers from the parts catalog, listed by model and serial number. Used lights and fenders from a salvage yard are fine. For the day-to-day record, the tractor operation log is a good place for notes. To find a yard or dealer near you, see the state directory. For safety background, the OSHA agriculture page is a good start, and for lockout work see OSHA lockout and tagout.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Agriculture · OSHA Lockout/Tagout