Parts & Salvage Directory

Telehandler Pre-Use Inspection Form

A telehandler is a tall machine with a long, moving boom, and a small mistake can tip it. A pre-use inspection is quick, and the operator should do it at the start of every day, because the person who drives it is the one who notices small changes. This is not a replacement for the operator's manual or training, but it helps you do the walkaround in a sensible order.

Ground level first

Park on level ground, boom fully retracted and lowered, engine off, and lock out the controls.

  • Tires: check for cuts, bulges and correct pressure. A soft tire changes how the machine sits under a load. Foam-filled tires do not need pressure checks, but still need a look for damage.
  • Frame and boom: look for cracks in welds, bent parts and fresh paint cracks, which often point to a stressed area.
  • Boom sections and wear pads: look for scoring and loose or missing pads. A boom that sags or wobbles more than it used to needs the dealer.
  • Hoses and cylinders: check for leaks and rubbing. Never test for a leak with your hand; use cardboard from a safe distance, and see the hydraulic injection first aid guide.
  • Fluids: check engine oil, hydraulic fluid and coolant.

The attachment and the load

Check the forks or bucket for bent tines, cracks and worn heels. Our pallet fork inspection checklist shows what to look for. Make sure the carriage latch or pin locks the attachment in place. Confirm the load chart in the cab is present, readable and matches the attachment you are using. The chart is the rule for how much you can lift at which boom angle and extension. Do not guess at it, and do not exceed it.

Cab and controls

Sit down, buckle in and adjust the seat. Start the machine and check gauges, warning lights, the horn, backup alarm and lights. Operate each function slowly: lift, extend, tilt and steering. Look for jerky movement and unusual noise. Check the parking brake, service brakes and the load-moment or stability indicator if equipped. If an alarm or limit does not work, do not run the machine and do not bypass it.

When to stop

Park it and tag it out if you see a cracked weld, a leaking cylinder, a boom that drifts down, brakes that do not hold, a missing seat belt or a stability system that does not respond. Also never lift people on forks or a pallet unless the machine is equipped and approved for it by the manufacturer. Check with OSHA or your manufacturer on operator training; the OSHA agriculture page is a start.

Parts notes

Keep spare pins, wear pads, hoses and filters, and write down model and serial numbers. A used set of forks or pads can be fine when inspected, but buy new for hoses, seat belts, boom chains, and safety systems. Link your findings to the front-end loader safety inspection if you run both machines.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Agriculture · OSHA Lockout/Tagout · CDC NIOSH Agriculture