Hydraulic Injection First Aid Guide
A hydraulic injection injury looks harmless at first. A pinhole leak in a hose can spray fluid fast enough to push it through skin, and the wound may show only a small puncture or a pale spot with little pain. Underneath, fluid and pressure can damage tissue badly, and the damage can progress for hours. Treat every suspected injection as a medical emergency.
If it happens
Shut the machine down, relieve pressure as the operator's manual describes, and get the person to an emergency room right away. Do not wait to see whether it hurts more. Tell the staff it is a high-pressure fluid injection, and take along the name of the fluid if it is on the container or the machine. Some injuries need surgical cleaning quickly, and the delay is where people lose fingers and hands.
While waiting for transport:
- Keep the person calm and still, and keep the hand or limb at rest.
- Do not cut the wound, squeeze it, or try to wipe fluid out.
- Do not apply heat or ice unless the medical provider tells you to.
- Do not let the person drive.
Call emergency services for guidance if the hospital is far away. Do not treat it as a minor cut, however good the hand feels.
How these leaks happen
Most injuries come from a person checking for a leak with a bare hand, or from leaning in to tighten a fitting on a pressurized line. A tiny crack in a hose or a worn spot rubbed against a bracket can create a spray you cannot see in daylight. Hydraulic circuits can hold pressure after the engine is off, especially with raised loaders or cylinders under load, so shutting off the engine alone is not enough.
Preventing the leak in the first place
Look at hoses regularly for abrasion, bulges, kinks, weeping at the crimp, and hardening. A hose with a damaged cover or exposed wire should be replaced. Use a piece of cardboard, not your hand, to look for leaks near a running machine, and wear gloves and eye protection. Hoses are a safety-critical part: use the correct replacement hose and fittings per the parts catalog and have it assembled by someone with the proper equipment. Do not buy used hoses. More on tracking weep spots is in the hydraulic system leak inspection log.
Before working on any circuit, lower implements to the ground, shut the engine off, and relieve pressure per the manual. The OSHA lockout page explains the general idea of controlling stored energy, and the skid steer daily inspection checklist shows where to look on loader machines.
Keep a first aid kit within reach of the shop, and make sure everyone who works on equipment knows this injury is an emergency.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Lockout/Tagout · CDC NIOSH Agriculture · AgriSafe