Pallet Fork Inspection Checklist
Pallet forks look simple, so they get ignored. Yet a fork that bends or breaks under a load can drop a bale or a pallet of feed onto a person, and used forks are one of the places where buying cheap can cost the most. A few minutes with the forks off the ground tells you most of what you need.
Start with the heel
The heel is the bend where the blade meets the shank. It is the highest-stress point on the fork, and the place cracks start. Clean it, then look at it with good light. A crack looks like a fine dark line, sometimes with rust bleeding out of it. Any crack at the heel means the fork is done. Do not weld it and keep using it; welding on hardened or heat-treated steel can weaken it, and a repair of a fork that carries loads over people is a job to leave to the manufacturer's guidance.
Also check how thick the blade is at the heel compared with the tip. Forks wear fastest at the heel from dragging on concrete and gravel. Many manufacturers publish a wear limit, commonly given as a percentage of original thickness; look for it in the manual or ask the dealer, and do not guess the number. Compare against the data plate if the fork has one.
Tips, straightness and spacing
Lay a straightedge along the top of each blade. Bent tines tilt loads or make pallets hard to enter. Check that the two forks are level with each other when set side by side; if one tip sits higher, the pair needs attention. Look at the tips for mushrooming or chipping.
Carriage, latches and hardware
Slide the forks along the carriage and check that they move freely and lock with the pin or latch. The locking pins should seat fully and spring back. Worn hooks on the fork carriage or notches on the frame allow the fork to jump out under a bounce. Look at the back of the carriage for cracks near the loader quick-attach; the skid steer daily inspection checklist and the telehandler pre-use inspection form cover the machine side. If you have a load backrest, check it for bends and cracks and make sure it is bolted tight.
Reading the markings
Forks and carriages carry a rating plate or stamping. If the plate is missing or unreadable, the capacity is unknown, so treat the fork as unrated until the dealer can identify it. Match the fork class to the carriage class; mixing classes is a common mistake with secondhand sets. Never load beyond what the machine's rated operating capacity allows with the forks mounted, which comes from the operator's manual and not the fork alone.
New or used
Buy new when you need safety-critical parts like forks, locking pins and latches. A used fork can be a decent choice for non-lifting-over-people tasks only if there are no cracks at the heel, the plate is legible and the class matches, but when in doubt, buy new. Keep the part number and the carriage class in your records.
For general safety guidance, see OSHA's agriculture page. Anything bent, cracked or missing a plate should come off the machine until a dealer looks at it.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Agriculture · ASABE