Rake & Tedder Maintenance Checklist
Rakes and tedders are cheap-looking machines that cause expensive problems when they quit. Hay lying in the windrow waits for nobody, and a tedder with a dead gearbox on the second day of a rain window costs a lot more than the part would have. Most of the trouble comes from a short list of wear items.
Tines and tine arms come first
Basket tedders and wheel rakes have dozens of tines, and each one is a spring steel part that bends, breaks or loses its tip. A few missing tines just leave strips of hay. But a broken tine tip that goes through a baler can end up in a cow, so look for pieces of tine and replace any that are broken off right at the arm. Walk the field edge after the first passes as well.
Check the tine arms and the mounting bolts. A loose tine arm will wear its hole oval and then the whole arm needs replacing. Retighten hardware to the torque in the operator's manual, not by feel.
Rotary rakes and tedders also need a look at the rotor rims and the arm bushings. A rotor that wobbles or runs out of true throws hay unevenly and will wear the bearings.
Bearings, gearboxes and drive
Spin each rotor or reel by hand with the machine locked out. Roughness, clicking or side play in the hub means the bearing is on its way. Grease points are numerous on these machines and are often hidden behind arms, so use the lube chart in the manual and make a note of each fitting you found. Overgreasing can blow seals, so follow the chart rather than pumping until grease squeezes out.
Gearboxes: check the oil level and condition at the plug the manual shows. Milky oil means water got in. Metal glitter on the plug magnet or in the oil means the gearbox needs work from a shop. PTO shafts and shields should also be inspected using the steps in the PTO safety and shield inspection form.
Wheels, hitch and folding hardware
Tires on rakes run low-speed but carry the weight of a lot of metal, so check inflation cold and look for sidewall cracks. Check the hubs for play. Folding wings and transport locks need to engage fully, and pins should be the right size, not nails or bolts that were handy. Before taking the rake on the road, run through the road transport safety checklist for farm equipment.
Parts worth keeping on the shelf
A box with spare tines, a few arm bolts and nuts, a set of bearings for the most common hub, and gearbox oil will cover most breakdowns. Write the part numbers on the box lid from the parts catalog. Rake and tedder manufacturers often change tine and arm designs between model years, so a tine from another machine may look the same but not fit properly. Matching the serial number range before buying a salvage tine arm or rotor saves a lot of guessing. Sheet steel covers and brackets are fine from a yard. Gearboxes and shields are better bought new or rebuilt by a shop with a warranty.
For an ongoing record of what has been replaced, keep notes in a machinery repair log.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: Penn State Extension · Iowa State University Extension · OSHA Agriculture