Parts & Salvage Directory

PTO Safety & Shield Inspection Form

A power takeoff shaft turns fast enough to wrap clothing, hair or a coverall sleeve before anyone can react, and the injuries from it are among the worst in farming. The shield is the only thing between the person and that shaft. Checking it takes five minutes, and it is worth doing at the start of every season and any time a shaft has been apart.

Walk the whole driveline

Shut the tractor off, remove the key, and block the implement so nothing can roll or drop. Follow lockout practice as described by OSHA. Then start at the tractor and work back.

At the tractor, the master shield over the PTO stub should be present and undamaged. A master shield that has been removed because it got in the way of hooking up is a common find on older tractors. Put it back, or replace it if it is cracked.

On the shaft itself, the plastic or metal tubes should spin freely and independently of the shaft. Grab each shield and try to turn it by hand. A shield that is stuck solid will turn with the shaft and become a hazard. A shield that wobbles badly, has a worn bearing ring, or has a split in the cone should be replaced. Do not tape or wire a cracked shield.

Look and feel for these problems

  • Safety chains that hold the shield from turning are missing, rusted through or tied to the shaft. They should be anchored to the tractor and implement, not to the shaft.
  • Shield cones and tubes with holes, sharp edges or cracks from being stepped on or caught on a drawbar.
  • Shield bearings that are dry or seized. Many have a grease fitting, and the manual shows where.
  • Telescoping tubes that bind, which can bend a shaft when turning. The tubes need grease per the manual, and they must still overlap properly at full extension and shortest length.
  • Couplers whose locking collar will not snap back, or whose pins are worn so the shaft can slip off the stub.
  • Clutch or shear bolt parts that have been replaced with whatever was handy. Use the exact part the manufacturer calls for.

Shaft length matters. A shaft that bottoms out in a sharp turn can destroy a gearbox or snap a shield. When an implement is moved to a new tractor, check length by raising and lowering it per the operator's manual before turning the PTO on.

What to stock and what to buy new

Keep a spare shield kit or the specific cone and tube section for each shaft on the farm, with the part number written on the shaft's data decal or in your parts list. The parts inventory tracking sheet is a handy way to record these. A used shield from a salvage yard can look fine and still be cracked inside the cone, so for safety shields, buying new from the dealer is the sensible call. Used shafts are a bigger gamble than most people think, since worn splines and a bent tube are hard to see.

Pair this inspection with the three-point hitch maintenance checklist, since the same hookup session is the best time to look at both. For training material on machinery safety, AgriSafe and NIOSH agriculture are reliable places to start.

Rule to live by

If a shield is missing, do not run the machine. Not for one quick pass, not to unclog something. Shut it down and fix it.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Lockout/Tagout · NIOSH Agriculture · AgriSafe Network