Skid Steer Daily Inspection Checklist
A skid steer gets more hours of hard abuse per year than most tractors on the place. It digs, pushes, lifts and spins in tight spots, often on dirt and manure that eat tires and pins. A five-minute walkaround at the start of each shift will find most of what fails, and it costs far less than a morning stuck with a loader arm down.
Walk around with the engine off
Start with the machine parked on level ground, bucket down and engine off. Look under it for fresh drips. A small amount of dirt-coated seepage on an old machine is one thing; a wet fitting is another. Check the engine oil, coolant and hydraulic fluid levels at the points shown in the operator's manual, and clean any radiator screen packed with chaff. A blocked cooler is a common reason a skid steer runs hot.
Next, inspect the tires or tracks. Look for cuts, bulges and missing lugs. On tracks, check for cracked rubber and loose tension. Low tire pressure makes the machine less stable, so set pressure to the manual or the sidewall rating when the tires are cold.
The parts people skip
- Quick-attach: Check that the latch pins fully extend and that the wedge and receiver are not worn or bent. A bucket that works loose is how people get hurt.
- Lift arm pivots and cylinder pins: look for slop and missing keepers. Grease them at the points and with the grease the manual specifies.
- Lift arm and cab: look for cracks in welds, especially around the rear of the lift arms and where the cab mounts.
- Safety bar, seat belt and door or lift arm lock: operate each one. If the interlock does not hold the controls when the bar is up, do not run the machine. Never defeat an interlock.
- Lights, backup alarm and horn.
Start-up and listen
With the operator seated and belted, start the engine and watch the gauges and warning lights. Cycle the lift and tilt slowly, listening for hydraulic whine or a jerky motion, which can mean low fluid or air in the system. Test the brake or park lock. Feel for the machine pulling to one side when driving straight, a sign of a hydraulic drive problem. For more on checking hoses, read the hydraulic system leak inspection log.
Never check a leak with your hand. A pinhole hose leak can inject oil under the skin, and that is an emergency; see the hydraulic injection first aid guide.
Parts to keep and what to buy new
Keep a spare set of quick-attach pins, grease fittings, a hydraulic hose or two with the right fittings and filters on hand. Write down each part number from the parts catalog using the machine's model and serial number. A used bucket, tires or a salvage cylinder can be sensible if inspected for cracks and wear. Buy new for hydraulic hoses, seat belts, safety bars and lift arm pins. If you find a cracked lift arm, a failing cylinder or an interlock that does not work, stop and call the dealer.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Agriculture · CDC NIOSH Agriculture · ASABE