Parts & Salvage Directory

Tractor Tire Pressure & Wear Record

Tires are the tractor's only contact with the ground, and pressure is the cheapest adjustment you can make. A tire run at the wrong pressure wastes fuel, wears early, packs soil and, on a road, makes the tractor handle poorly. The right pressure is not a single number. It depends on the tire size, the load, the speed and the job, and the tire maker publishes it.

Finding the right number

Start with the tire's sidewall for size, and look up the load and inflation tables from the tire manufacturer or the tractor manual. Ask a tire dealer if you are not sure, especially when carrying heavy weights or a loader. Tractor tires often run at low pressures, so use a low-pressure gauge, not a truck tire gauge. Check cold, before the tractor has run, because heat raises the reading. Never exceed the maximum on the sidewall.

Reading the wear

Walk around each tire and note:

  • Lugs worn down at the center and not the shoulders: probably overinflated.
  • Shoulders worn more than the center, or cracks at the lug base: possibly underinflated or overloaded.
  • One side worn more than the other: toe-in or a bent tie rod, or a tractor that works the same slope each time.
  • Cuts, bulges and exposed cord in the sidewall: a failing tire. Stop using it.
  • Weather checking, small cracks in the rubber: ageing from sun and ozone. Cover or park tires out of sun when you can.

A bulge in a sidewall is a failed internal cord and can burst. Do not sit near a tire that you suspect is damaged, and do not try to reinflate one that has been run flat unless a tire shop does it with the right cage.

Wheel and rim checks

Look for loose or missing wheel nuts, rust trails around a stud, and cracks around the stud holes. A rim that is bent or has a crack at the weld should be replaced. Check for slow leaks by watching pressure over a week. Liquid-filled tires need a specific valve and gauge, and shop service. For ballast questions, see the tractor ballast and weighting guide, and the tractor daily pre-operation inspection checklist shows where a quick tire look fits in each day.

What to write down

Make a one-page record for each tractor with tire size and brand, the pressure you settle on for each job (such as field work, road work and loader use), the date you checked it, and any wear you noticed. Add the date a tire was installed and the hours at the time. Over a season, you can see which tire loses pressure and which is wearing odd. Adding the entry to your tractor operation log keeps everything in one place.

New versus salvage

Used rims and wheel centers from a salvage yard can be good, provided they are straight and the bolt pattern and offset match your tractor. Look closely for cracks, and use new studs and nuts. Buy new tires unless a tire shop can inspect the casing, and never mount a tire that is cracked or has sidewall damage. To find yards and tire shops near you, see the state directory. Mounting tires is dangerous work, so leave it to a tire shop with the right equipment; see OSHA agriculture for safety information.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Agriculture · Extension.org