Parts & Salvage Directory

Shop Tool Inventory & Maintenance Log

Anyone who has spent twenty minutes searching for the one wrench that fits knows the cost of a shop that is not tracked. A tool inventory is not about paperwork. It is about knowing what you own, where it is, and whether it is safe to use, so when a machine breaks during a busy week, repair time goes to the repair.

Start with a walk through the shop

Take one afternoon and look at everything. Group tools by what they do: hand tools, torque and measuring tools, power tools, welding gear, lifting equipment, air and hydraulic tools, and specialty tools that belong to one machine, such as a bearing puller for a certain hub or a timing tool for one engine. Specialty tools are the ones most worth listing, because they are the ones people forget they own and then buy again.

For each item, write down the name, where it lives, and its condition. Photographs help. For tools tied to a particular machine, write the model beside the entry. Sort of like the parts list you already keep, which you can track with the parts inventory tracking sheet.

What to check and how often

Some tools need regular attention and some just need to be looked at before use:

  • Torque wrenches should be stored unloaded and sent for calibration according to the maker's guidance.
  • Cords, plugs and grounding on electric tools; frayed or taped cords come out of service.
  • Grinders: wheels have a rating and age, and a cracked or damaged wheel gets replaced. The grinder safety inspection checklist goes into this.
  • Lifting gear, including jacks, stands, and hoists, with a close look at pins, welds and chains. Never replace safety pins with substitutes.
  • Air tools need oil and clean air and should be checked for leaks at fittings.
  • Hydraulic jacks and presses: look for leaks and bent parts.

A tool that is damaged should be tagged and set aside, not hung back on the board. A simple tag saves someone from picking up a cracked socket on a rushed day.

Keep it simple enough to use

The best log is one that gets used. A notebook or spreadsheet is fine. Mark tools with a color or label if tools travel between the shop and the field. Note who borrowed what, and when it should return. After a month of use, trim the log to what is actually helpful.

Keep consumables on the same list: grease, shop rags, cutting oil, spare bits, cutting discs, safety glasses and hearing protection. Check the shop against the farm shop safety audit checklist once a year as well.

Replacing and stocking

Buy hand tools you will use often in good quality, since they tend to last. Used tools from auctions and yards can be a bargain for sockets and wrenches, but be wary of used lifting gear, grinders, and anything with a safety rating. Lockout and training resources are found through OSHA.

After the shop work is done, a place for farm humor and stories is farm.FM, which makes a decent reward for a tidy toolbox.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Lockout/Tagout · NIOSH Agriculture · AgriSafe Network