Parts & Salvage Directory

Grinder Safety Inspection Checklist

A grinder is one of the most common tools in a farm shop and one of the easiest to hurt yourself with. A wheel that breaks at speed throws pieces hard enough to cause serious injury, and a sparks shower in the wrong place starts a fire. A minute of checking beforehand prevents both.

Check the wheel before every use

Look at the abrasive wheel for chips, cracks and gouges, and never use one that has been dropped or got wet and was left. Tap a clean dry wheel lightly and listen. A good one rings clearly, a cracked one gives a dull thud. If in doubt, throw it out, because wheels are cheap and eyes are not.

Match the wheel to the tool and the job. Every wheel is marked with a maximum speed, and that rating must be at or above the grinder's speed. Never use a cutting disc for side grinding, and never fit a wheel that does not fit the arbor properly. The manual for your grinder and the wheel label tell you what is correct.

Guards, rests and setup

Leave the guard on. Many accidents begin with a guard removed to reach a corner. On a bench grinder, set the tool rest close to the wheel, as the manual specifies, so a workpiece cannot jam between wheel and rest. Let a new wheel run for a minute before you stand in line with it, and stand to the side while it comes up to speed.

On an angle grinder, use the side handle, keep the cord clear, and check the switch operates cleanly and releases when you let go. Look over the cord for cuts. Plug into a grounded outlet and use a GFCI if the floor is damp, a rule the farm shop safety audit checklist also covers.

Protect yourself and the shop

Wear safety glasses with side shields, and a face shield for heavy grinding, plus hearing protection and gloves that will not catch. Tie back long hair and loose sleeves. Grinders are loud, and hearing loss builds up quietly. The CDC NIOSH noise page explains why.

Sparks travel farther than you think. Clear away rags, oil, solvents, hay and dust before you grind, and keep an extinguisher nearby. Check the workshop ventilation checklist as well, since grinding dust in a closed shop is not good to breathe.

Parts and when to buy new

Keep spare wheels, brushes, a spare side handle and a guard that fits your model. Write the model and serial number from the tool plate in your shop log. A used grinder from a salvage sale may look fine, but check that the guard, cord and switch are intact, and that the spindle has no play. Always buy new wheels and guards. Do not grind on a wheel stored where it can freeze, get wet or be bumped, and keep wheels on a dry shelf.

When a grinder starts to vibrate, hum oddly or throw sparks from the motor, take it out of service until a qualified repair shop has looked at it.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: CDC NIOSH Noise · OSHA Agriculture · ASABE