Parts & Salvage Directory

Shop Crane Inspection Checklist

A shop crane, often called an engine hoist, lifts things that can kill a person: engines, transmissions, axles, loader parts. It is also a tool that sits in a corner for a year and then gets pulled out on a day when someone is in a hurry. A short inspection before each use, and a more careful one each season, keeps it from being the weak link.

Before every lift

Look the crane over standing back from it first. Does it sit square? Are the legs bent, twisted or showing cracked paint at the welds? Roll it a few feet. Casters that bind, wobble or have flat spots make a loaded crane hard to control and prone to tip.

Check the hydraulic ram. Oil seeping down the cylinder or collecting at the base means a bad seal. The boom should rise smoothly and hold, and if it settles under load, do not use it. Test with no load first, then raise and lower the boom through its range.

Examine the boom, its extension holes and the pins. Use the correct pin for each hole, never a bolt or a nail. The rated capacity usually changes with boom extension, and the data plate shows it, so read it before lifting. If the plate is missing or unreadable, find the manufacturer's capacity chart.

The parts that carry the load

  • Hook: look for spread throat, cracks, deep nicks, and a safety latch that does not close. A hook that has opened up has been overloaded. Replace it.
  • Chain or strap: inspect every link for stretch, gouges, rust pitting, and bent links. Replace worn chain rather than repairing it; see chain hoist inspection log for the same kind of check on a hoist.
  • Load leveler and bolts: these are easy to overlook, and a missing nut can let a load tilt.
  • Welds and brackets at the boom base and leg joints: cracks mean retire it.

If a crane has been dropped, hit by a vehicle, or has bent legs, do not weld and keep using it. A weld repair can alter the metal and the capacity rating. Replace the crane or have the manufacturer or a qualified shop assess it.

Using it safely

Keep the load as low as practical when moving it. Move slowly over smooth concrete, never on ramps or uneven ground. Keep the boom retracted and the load close to the mast, which increases stability and capacity. Never reach under a load held only by the hydraulics, and use stands or blocks when work must happen below. People should stay out of the line of travel. The farm shop safety audit checklist has other shop hazards to check at the same time.

Parts and replacement

Hooks, chains, pins and hydraulic seals should be bought from the manufacturer or an equivalent rated source, with the capacity marked. Salvage or used parts are not a good idea for anything in the load path. Casters and general hardware can be replaced with new matched parts.

For safe practices, the OSHA agriculture page is a starting point, and the machine's manual covers its rated capacity.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Agriculture · NIOSH Agriculture · AgriSafe Network