Parts & Salvage Directory

Chain Hoist Inspection Log

A chain hoist in the farm shop usually gets used right when something heavy is already half unbolted, which is the worst moment to find out the chain is stretched. A hoist is cheap compared with a dropped engine or a hurt hand, so it deserves a short inspection before every lift and a closer look at the start of each season.

Before every lift

Do this each time, it takes a minute:

  1. Read the load rating plate on the hoist body. If the tag is missing or unreadable, treat the hoist as unusable until you can verify its rating with the maker.
  2. Run the chain through your fingers (hoist unloaded and the power or hand chain secured). Feel for nicks, gouges, bent links, rust pitting and links that no longer swing freely.
  3. Look at both hooks. A hook that has opened up at the throat, or one with a bent or missing safety latch, is done. Do not straighten and reuse it.
  4. Cycle the hoist up and down with no load. It should run smooth, with no skipping, grinding or chain jumping in the pocket wheel.
  5. Check the anchor point: the beam, trolley or chain you hang it from must be rated for the load too.

Signs the chain is finished

Chain stretch is the quiet killer. Links elongate under repeated heavy loads, and a stretched section will often show as a section that no longer lies neatly in the pocket wheel. Compare a few links near the hook with links from the lightly used slack end; if the worked links look longer, or the chain feels like it is climbing the wheel, stop. The maker's manual spells out wear limits for your model, so measure to that, not to a guess.

Also watch for weld spatter, heat discoloration from a torch or arc strike, and rust that has eaten into the link rather than just stained it. Any of those retires the chain. Never repair a load chain with bolts, wire or a field weld.

Brake and load behavior

The load brake is what holds the weight when you let go. Lift a small test load a few inches off the floor, pause and watch it. If it creeps down, or the hoist clicks and slips, take it out of service. Do not tinker with the brake internals unless the manual calls for it and you have the correct parts kit.

Parts and salvage notes

Keep the model and serial number in your log, along with the date of purchase if you know it, so a dealer can match chain and hook parts. Hoists are lifting devices, so this is one place where new is the safer buy: load chain, hooks, latches and brake parts should be genuine or maker-approved parts, not mixed salvage. A used hoist of unknown history is a gamble; if you do buy one, insist on a legible rating plate and a documented chain.

Related shop habits

Slings, shackles and chains used with the hoist need their own checks, and the overall shop setup is covered in the shop crane inspection checklist and the farm shop safety audit checklist. Never stand under a suspended load, and support heavy components on stands or blocks before working under them. For general guidance on shop hazards, see OSHA's agriculture page.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Agriculture · ASABE