Parts & Salvage Directory

Pressure Washer Maintenance Record

A pressure washer earns its keep in a farm shop, cleaning manure spreaders, trailers and combine heads. It is also an unforgiving machine. Pumps run dry, freeze, or get fed dirty water, and each of those costs far more than the routine care that prevents them.

Pump and oil

Most pressure washers use a triplex or axial pump that has its own oil. Check the sight glass or dipstick on level ground, and change oil per the manual. Milky oil points to water in the pump, usually from a seal that has started to fail, and it needs attention before it ruins the pump. Never run the pump without water; even a few seconds dry can damage seals. Always turn on the water, squeeze the trigger to purge air, and only then start the engine or motor.

Inlet, hoses and nozzles

The inlet screen is a small filter where the garden hose connects. Pull it out and clean it often, especially if you wash with pond or well water. A clogged screen starves the pump and can cause cavitation, which sounds like gravel and pulses at the gun.

Inspect the high-pressure hose for kinks, bulges and exposed braid. A damaged hose can burst, so replace it with one rated for the machine's working pressure, which is on the pump or the data plate. Do not splice or repair a high-pressure hose with a cheap coupler. Check the quick couplers for leaks and worn o-rings.

Nozzles wear with use, and a worn nozzle sprays wider and cleans less. Compare it with a new one or check the spray pattern. The nozzle size is stamped on it, so write it down. If the pressure pulses or drops, check the unloader valve and the spray gun before blaming the pump.

Engine or motor care

For gas units, treat the engine as you would any small engine: check oil, replace the air filter and use fresh fuel with stabilizer for storage. The portable generator maintenance log covers similar routines. For electric units, inspect the cord and plug, use a properly rated ground-fault circuit interrupter outlet, and keep connections off wet ground.

Winter and storage

Freezing is the main killer. Water left in the pump can crack the housing. Drain the machine, then run pump antifreeze through it per the manufacturer's directions before storing in a cold shop. Write the date in your record.

Safe use

A pressure washer can cut skin, and high-pressure injection injuries can look minor yet are serious. Never point the wand at a person or pet. Keep spray away from electrical panels, wiring and bearings. Wear eye protection, boots and hearing protection as needed. Never use it on a ladder or while standing in a spot that could slip. Washing grease and manure into drains can raise environmental concerns, so check with your state agency or the EPA's agriculture page for the rules that apply.

For the cleaning that comes with it, the farm shop safety audit checklist covers wet-floor and electrical hazards.

Parts to keep

Stock pump oil, o-rings and seals, an inlet screen, a spare nozzle, and the spark plug or filter for gas units. Note the pump model and serial number from the tag so the parts counter can match them. Pumps and unloaders can come from salvage if the machine is the same model, but buy high-pressure hoses and spray guns new. If the pump leaks oil or runs rough after a freeze, stop and call a small-engine shop.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: EPA Agriculture · OSHA Agriculture