Parts & Salvage Directory

Portable Generator Maintenance Log

A generator that has not been run since last winter is one that will not start during the next ice storm. Portable units sit idle for months, and the usual failures come from stale fuel, a dirty carburetor, a weak battery or a pull cord that finally gives out. A short routine, and a log to prove you did it, solves nearly all of it.

Fuel is the main enemy

Gasoline goes stale, and ethanol blends pull moisture and gum up small passages in a carburetor. If the generator will sit, either use a fuel stabilizer according to the label, or run the carburetor dry per the manual's instructions. Drain old fuel from the tank and the carburetor bowl if the unit has been stored a long time, and dispose of it properly. Store fuel in approved containers away from the generator and any ignition source. Never refuel a hot or running generator; let it cool first.

Routine to run through

Every few months, and before storm season, work through this list:

  1. Check the engine oil level on level ground, and change oil on the schedule in the operator's manual. Write the hours in the log.
  2. Inspect the air filter and clean or replace it per the manual.
  3. Look at the spark plug for wear or fouling, and replace it if needed with the type the manual specifies.
  4. Check the fuel line and fittings for cracks or leaks.
  5. Start the unit and run it under a load. A generator that runs fine with no load can stumble when you plug something in.
  6. Check the outlets, breaker and cord for damage.

Log the date, hours, what you did, and any parts replaced with their numbers. The engine oil and filter change tracker works the same way for your tractors.

Run it safely

Run a generator outdoors only, well away from doors, windows and vents, because carbon monoxide kills quietly. Never connect it to house wiring without a properly installed transfer switch put in by a licensed electrician. Keep it dry, grounded as the manual instructs, and never overload it. Learn the rated output from the data plate and add up the starting load of motors before plugging them in; motors draw more to start than to run. Ready.gov has general guidance for power outage safety.

Parts to keep and where to get them

Keep a spare spark plug, an air filter, oil, a fuel filter if the model has one, and a spare pull-cord assembly or recoil starter if parts are available. Write the model and serial number from the data plate into the log so the parts counter can match them. Small engines of the same family often share parts, but match the part number, not the look. A used generator head or engine from a salvage source can be fine for a non-critical unit if it turns freely and the windings show no burn smell or damage. Do not buy used safety parts like fuel shutoffs or wiring.

For electrical troubles that go beyond a plug and a filter, see the electrical system troubleshooting worksheet and call an electrician for anything involving panel work.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: Ready.gov · OSHA Agriculture