Parts & Salvage Directory

Grain Auger Safety Inspection Checklist

A grain auger looks simple, but the exposed flighting and the driveline have injured and killed a lot of farmers and kids. Almost every one of those accidents had the same ingredient: a guard that was missing, or someone who stepped in to clear a jam while the machine was still running.

Before you start it up

Walk the auger from the tractor to the discharge. Start with the guards. The PTO shield must be on and turning freely on the shaft, and the intake needs its grate or guard so a boot or sleeve cannot reach the flighting. If a guard is bent or missing, replace it with a new one from the dealer. A shield from a salvage yard is not a good bargain for something that protects your arm.

Then the machine itself:

  • Driveline: look for worn universal joints and a shaft that binds or has play. Telescoping sections should slide and not be bent.
  • Flighting and tube: look for wear or holes where the tube has thinned out, and listen for flighting that rubs the housing.
  • Gearbox or drive belt: check for leaks and loose mounting bolts, and the correct oil level per the manual.
  • Wheels, tires and the lift winch: look at the cable for frays and the winch for a good working brake. Never use the auger with a damaged cable.
  • Hitch and stand: make sure it is stable and will not tip or roll when set.

Power lines, setup and lockout

Look up before moving or raising the auger. Contact with an overhead line is a leading cause of grain auger deaths, so lower the auger to transport height and keep the whole machine well away from lines. Park on firm level ground, chock the wheels and set the tractor brake.

Before anyone touches the intake or tries to clear a plug, shut the power off, remove the key, wait for everything to stop turning, and tag it. Read the OSHA lockout and tagout page for the principle, and the PTO safety shield inspection form for driveline detail.

Working around bins and children

Never walk into flowing grain. Entering a bin with grain moving, or on a crusted pile, can bury a person in seconds. The CDC NIOSH grain handling page has plain-language guidance on bin entry and rescue. Keep children well away from the work area. An auger is not a toy and the hopper is not a place to play or sit.

Parts to keep and when to call a pro

Flighting sections, bearings, a spare driveline and a couple of belts cover most repairs. When buying a used section or gearbox, match model and serial range, check for cracked castings and bent flighting, and turn the shaft by hand. Do not weld flighting or a tube that has wear holes unless you know what you are doing. If the housing is thin, replace it. Brakes, lift cables and guards should always be new.

When you finish, the grain cart maintenance record will help you keep the rest of the harvest line in shape. If a new part is hard to find, the state directory points to parts and salvage yards by state.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: CDC NIOSH Grain Handling · OSHA Lockout/Tagout · OSHA Agriculture