Grain Cart Maintenance Record
A grain cart does its hardest work in a short window, when a breakdown costs the most. The best cart maintenance is boring and done in August, not in the middle of a field on the first dry day.
What to log and why
Keep a small notebook in the cart or a note on your phone, and write down the date, engine or tractor hours, and what you did. The log matters most for three things: what lubricants went into the gearbox, when bearings and chains were last greased, and what parts you replaced and the part number. When something fails, a good record tells you whether it was bad luck or neglect, and it makes ordering the next part quick.
Also write down the cart model and serial number, plus the tire size and the model of the scale if one is fitted. Those are the first things a parts counter asks for.
The unloading system
The auger system is the heart of the cart. Look at the flighting edges for wear, and check the lower and upper auger bearings for play or heat marks. A bearing that runs hot will announce itself with a smell or a blue stain on the housing. Check the gearbox oil level and look for weeping around seals, using the lubricant type in the manual.
Look at the unload clutch or hydraulic gate and see that it engages cleanly and fully. Engage it with the tractor idling and the area clear. Slipping clutches wear fast, and a sticky gate leads to slow unloading and rushed operators.
Running gear, brakes and hitch
Check the tire sidewalls for cuts and bulges and set pressure cold per the tire placard or the manual. Grain carts are heavy and tires work hard. Repack or inspect wheel bearings, and use the wheel bearing repack record if you want a model for logging it. If the cart has brakes, test them at low speed before loading. Brakes are a safety part and should be replaced new, not patched.
Look at the hitch pin, clevis and safety chains. A cart can push a tractor on a slope or in a downhill field, so everything must be tight and in good shape. See the implement hitch safety chain inspection for detail. Never ride on the drawbar or the ladder while the machine moves.
Parts to stock before harvest
Greaseable fittings, a spare auger bearing, a gearbox seal kit and a few hydraulic hose ends will cover many field repairs. Salvage can work well for sheet metal, ladders and spare shafts. When you buy a used gearbox, bearing housing or auger section, check castings for cracks, match the serial range, and turn the shaft by hand. Avoid used brake parts, safety chains and shields.
Update the log at the end of the season, so the next owner or the next you will know what shape it is in. The grain auger safety inspection checklist covers lockout habits that apply here too, and OSHA's agriculture page at https://www.osha.gov/agriculture has the official rules.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Agriculture · ASABE · Iowa State Extension