Parts & Salvage Directory

Chainsaw Safety & Maintenance Checklist

Most chainsaw injuries on farms happen to people who knew better: a dull chain, a rushed cut, a saw that was fueled while hot. A saw that is cared for cuts faster, vibrates less and gives you far more warning before something goes wrong.

Read the chips

A sharp chain throws big, uniform chips. Fine sawdust, smoke at the cut, or a saw that pulls to one side means the chain is dull or the cutters are uneven. Pulling to one side usually means one side of the chain is sharper than the other. Sharpen to the angles and file size in the operator's manual, and keep depth gauges set per the same instructions. If you cannot get a chain cutting straight after a couple of tries, replace it. A chain is a cheap part compared to a ruined bar or a kickback injury.

Bar, sprocket and chain wear

Check these every time you fill the saw:

  • Bar rails: look for burrs, uneven wear and a groove that has widened enough that the chain rocks. Flip the bar over regularly so wear stays even.
  • Drive sprocket: a sprocket worn into a pattern that matches the chain links will chew a new chain quickly. Replace it along with a worn chain.
  • Chain tension: snug against the bar but able to be pulled around by hand when the saw is off. Chains stretch when new, so recheck after the first few cuts.
  • Oiler: the bar should wet your cutting surface. A dry bar overheats fast. Clean the oil port and the groove when it is gummy.

Safety features that must work

Before you pull the cord, test the chain brake: with the engine off, push the hand guard forward and confirm the chain locks, then release it. Look for the chain catcher, the spiked bumper, the throttle lockout and the anti-vibration mounts. A saw with a missing or taped-down safety feature goes in the shop, not into the woods.

Wear chaps, eye and face protection, hearing protection, gloves, a helmet and sturdy boots. Both hands on the saw, stand to the side of the cut line, and never cut above shoulder height. Know where the bar tip is, because most kickback comes from the nose touching something. Fuel with the engine cool and off, move at least a few steps away before starting, and store fuel only in approved containers.

Air, spark and fuel

A clogged air filter or fouled spark plug is behind most hard-starting complaints. Clean the filter, check the plug per the manual, and use the fuel and oil mix the manufacturer calls for. Old fuel in the tank gums the carburetor; drain it before long storage.

Parts and salvage notes

Write the model number from the saw and the chain pitch and gauge from the bar, plus the drive link count. A new chain must match all three. Salvage saws are fine as parts donors for carburetor kits, covers and handles, but buy new for chains, brake bands and safety components. For related shop practice see the welder safety and maintenance checklist and the farm equipment fire prevention checklist. Noise and vibration are real long-term hazards; NIOSH noise guidance explains why hearing protection matters.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: CDC NIOSH Noise · OSHA Agriculture