Parts & Salvage Directory

Slurry Tanker Maintenance Checklist

Slurry is hard on equipment. It is wet, corrosive and full of solids, and it sits in a tank that rarely gets a good rinse until the season ends. The result is a machine that rusts from the inside, plugs at the worst moment and wears out pumps faster than most other farm equipment. A tanker that gets a little attention each spring and a good wash each fall lasts a lot longer.

Start with the tank and the running gear

Walk around the empty, clean tank and look at the seams, welds and mounting points for cracks and for weeping. Pay particular attention to the bottom and the areas around baffles, where solids settle and rust works through. A tank that has thin spots is not just a leak risk; it is a structural risk when loaded. If you find soft or flaking metal, have a welder or the dealer evaluate it before you haul another load.

The axle, hubs and brakes carry a heavy, shifting load, so check them closely. Grease the hubs per the manual, check for loose wheel nuts, and look at brake components for wear and leaks. Our guide on brake adjustment for trailers explains what to check. Inspect the hitch, pins and safety chains too, since a surging liquid load pushes hard on them.

Pump, valves and plumbing

The pump is the heart of the system. Listen to it when it is running. A pump that pulls air will rattle and lose suction, which often means a worn seal, a loose hose clamp or a cracked suction hose. Check the drive shaft and its shield. Never run a PTO-driven pump without the shield in place, and follow the PTO safety and shield inspection form before you hook up.

  • Valves: operate each one. A valve that is stiff or does not seal fully will drip on the road and make pressure tests useless.
  • Hoses and couplings: look for cracks, bulges and worn gaskets. Replace cracked gaskets, not just the hose.
  • Level sight or float: clean it so you can actually see the fill level and avoid overfill.

What goes wrong in the field

Plugging is the most common complaint. Chopped straw, bedding or a stray rock in the line stops flow, and if you clear a plug by opening a fitting you may be hit with slurry under pressure. Release pressure first and wear eye protection.

Manure gas is a serious hazard around tanks and pits. Hydrogen sulfide can drop a person in seconds, so never enter a tank or lean over an agitated pit, and keep people away when agitating. Review the CDC NIOSH agriculture page for guidance.

Parts and wear items

Keep spare pump seals, a spare hose and gaskets, valve parts, grease fittings and bulbs. Record part numbers from the parts catalog and the pump's model and serial number. Used pumps and valves are sometimes worth it, but turn the shaft by hand and check for worn housings. Buy new brake parts, hitch pins and PTO shields.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: CDC NIOSH Agriculture · OSHA Agriculture · ASABE