Parts & Salvage Directory

Round Baler Belt Tension Checklist

Most round baler headaches that show up in the field trace back to the belts: bales that come out soft in the middle, a belt that wanders off to one side, or a squeal that starts as soon as the bale gets heavy. Belt problems are cheaper to prevent in the shop than to solve in the windrow.

Start with the symptoms

A belt that tracks to one side. The belts should run centered on the rollers. Wander usually points to a bent or dirty roller, a belt that is stretched unevenly, or a tension setting that is off. Look for crop wrapped around a roller, especially at the ends, and clean it out with the baler locked out. A cracked or bent roller needs replacing, since you cannot tension your way around a bad roller.

Slipping or squealing. Belts that slip glaze and wear fast. Check the tension indicator or spring setting. The correct setting is in the operator's manual for your model, and it is not something to guess at or adjust by feel. Also look for wet or dirty rollers, and for any oil or hydraulic fluid leaking onto belts.

Soft cores or odd bale shape. Uneven tension between belts, a worn tension arm bushing, or a stretched belt are possible causes. Look for tension arms that bind or a spring that has lost its strength.

What to check before the season

With the baler locked out and the tailgate secured, do this:

  1. Inspect belt surfaces for cracks, cuts, fraying edges and a polished look.
  2. Examine the lacing or splice: look for pulled-out fasteners and broken lacing pins. A lacing that fails in the field can wreck a belt.
  3. Check roller bearings and ends by spinning each by hand. Growling or tight spots mean bearing replacement.
  4. Look at the tension arms, springs or cylinders, and the pivot bushings. Replace worn bushings in pairs.
  5. Check the tailgate latches and hoses with an eye for leaks and bad crimps.

Rolls of old twine or net wrap sitting behind a shield can cause belt damage, and so can stones and wire. Be careful with the pickup; the rake and tedder maintenance checklist covers what should be done before the hay reaches the baler, and the bale wrapper maintenance log covers what comes after.

Parts decisions

Belts are expensive, and a used belt from a salvage yard is a gamble because age and hidden damage are hard to judge. Rollers, brackets, and frames can often be salvaged if the model and serial number range match, and a bent roller is worth swapping from a yard machine. Hydraulic hoses and tension components that carry load should be bought new.

Record the baler model, serial number, and belt part numbers before the season. Belt kits are specific to the baler, and a belt that is a few inches off will not seat.

When to call the dealer

If belts keep tracking off after cleaning and roller replacement, if the frame looks twisted, or if tension adjustment does not change anything, stop. Frame alignment and tension system problems are beyond what a quick fix will cure. For general hay equipment guidance, see Penn State Extension and always lock out per OSHA before reaching in.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: Penn State Extension · OSHA Lockout/Tagout · University of Nebraska-Lincoln Extension