Bale Wrapper Maintenance Log
Bale wrapping is a short season with a long cost if something breaks. Haylage that sits unwrapped for a day or two can spoil, so the wrapper must work the first time it is needed. Most trouble comes from a handful of wear items.
The film path
The stretch unit is where the film gets pulled thin. Look at the rubber rollers for glazing, cuts and flat spots, because a roller that has lost its grip will slip and give uneven stretch. Check the gears that link the two rollers. Chipped teeth or stripped gear faces mean ragged wrapping. Clean any stuck film residue off the rollers with the cleaner the maker recommends, and do not scrape with a knife.
Check the film holders, the cut-and-hold mechanism and any film sensors. A film sensor that is dirty or off its bracket can stop the machine for no reason. Make sure the arms swing freely and the spindles are not bent.
The turning and driving parts
On a table wrapper, the rollers that rotate the bale wear on the surface and in their bearings. Turn each by hand and feel for roughness. A flat belt or chain drive should have the tension the manual calls for. Chains that are stiff or dry will stretch, so lubricate as the manual says and check sprocket teeth for hooks.
On an in-line wrapper, check the ring bearing or the rollers that carry the wrapping ring, plus the drive wheels. Uneven wear means the ring may sit out of true. Look at the frame for cracks around the pivot and the hitch, and at the support rollers for flats.
Hydraulics and electronics
Run the wrapper through a cycle with nothing on it and watch for slow or jerky motion. Check hoses and fittings for weeping, and check cylinder rods for pitting. Inspect the wiring harness, the counter and the controller for corroded plugs and rubbed insulation. Rodents love wrappers in storage, so look for chewed wiring. The electrical system troubleshooting worksheet has more on tracing a bad connection. Keep hands and tools out of the film path and arms while anything can move, and lock out before servicing, per the OSHA lockout/tagout guidance.
Spares worth carrying
Keep a log of when you changed rollers, belts and chains, and of the part numbers. Write the model and serial number inside the cab or on a card in the shop. A short list of spares for hay season usually includes:
- stretch rollers or the gears that drive them
- a drive belt or chain and a master link
- the film sensor and its connector
- a spare hose and fittings for the likely rubbing spots
Rollers and chains are a good place to buy new, since the grip surface and the fit matter. Used hydraulic valves, frames and pivots can be a good buy from a salvage yard if you match the serial range and inspect the casting for cracks. Use the state directory to find a parts source close to you.
Finish the season by cleaning out film scraps, greasing every fitting, and storing the machine under cover. A related guide is the round baler belt tension checklist, which covers the machine that feeds your wrapper. A hay equipment maintenance calendar will help you schedule it all.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Lockout/Tagout · Extension.org