Hay Harvest Equipment Checklist
The morning the forecast turns dry is a bad time to learn the mower conditioner has a cracked roll or the baler has a bad pickup bearing. The point of a pre-harvest check is to find those things a week or two ahead, while you can still order parts.
Cutting and conditioning
Start at the mower. Pull the shields as the manual describes, and look at every blade or knife for chips, cracks, and uneven wear. A blade that has been bent by a rock and straightened is not a good blade. Replace sets, not single pieces, so the cutterbar stays balanced; an unbalanced disc shakes bearings loose. Check blade bolts and retainers against the manual rather than guessing.
On a conditioner, turn the rolls by hand if the design allows and watch for flat spots, gouges, and uneven gap. Listen for dry or rough bearings. Check belts for glazing and cracked edges. If a belt or chain looks borderline, replace it now, since a field failure costs a day.
Raking, tedding, and the baler
Rakes and tedders have dozens of tines that bend and fall out. Missing tines leave strips of hay behind and leave sharp stubs that can hurt hands and tires. Check the arm bushings and the lift linkage for slop. See the rake and tedder maintenance checklist for a closer look.
On the baler, check pickup teeth, bearings, drive chains, and the oiler if equipped. Square balers depend on the knotter and needle system, so give that area time. On a round baler, belts, rollers, and the tension system matter most; the round baler belt tension checklist covers that part.
Shields, lockout, and the tractor
Every shield that was removed for service goes back on before the engine starts. PTO shields must spin freely on their own and not turn with the shaft. Shut the engine off, remove the key, and wait for all motion to stop before clearing a plug or touching a knotter. The OSHA agriculture page is a good place to confirm general machinery safety practice.
Also check the tractor: tire condition, hitch pins, the safety chain, and lights and SMV emblem if you will be on the road with hay.
Parts worth having in the box
Keep spares of the items that stop work: shear bolts or pins of the exact type in the manual, a few knife sections or blades and their hardware, a belt or chain link, grease, and gear oil. Write part numbers from the parts catalog on a card in the box.
If you buy used, inspect for cracks and wear, and match serial ranges. Buy new for brakes, hitch parts, shields, and hoses.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Agriculture · ASABE · Extension