Gravity Wagon Inspection Form
A gravity wagon is a plain machine, and that is exactly why it gets ignored. It rides on a few bearings, a kingpin, a tongue and four tires, and when one of those goes at harvest, a loaded wagon is a very large problem.
Walk the running gear first
Park on level ground, set the brake and chock the wheels. Start at the tires: check for sidewall cuts, bulges and old dry rot, and set pressure cold to the tire placard. Look at wheel bolts or nuts for tightness. Jack up each corner safely with stands and spin the wheel to feel the bearings. A grinding or rough spot, or a wheel that wobbles, means the bearings need attention. The wheel bearing repack record explains how to log it.
Next the running gear itself. Look at the bolster and the king pin area for cracks, wear and loose fittings. Welds on running gears take stress, and rust streaks beside a weld are a warning. The front axle should pivot freely. A wagon that tracks wrong or wanders on the road has a bent tongue, worn pivot or damaged axle.
Tongue, hitch and brakes
The hitch is the part that keeps a loaded wagon behind the tractor. Inspect the tongue for bends and cracks, check the clevis or hitch eye for wear, and use a pin of the right size with a retainer. A wagon needs safety chains, rated for its weight, and they must be attached properly. The implement hitch safety chain inspection goes through the detail.
If your wagon has brakes, test them at low speed with a load. Look at hoses, cylinders and cables, and adjust only per the manual. Loaded wagons can easily push a tractor downhill, so brakes and tractor weight both count. Never ride on the tongue or the wagon.
Box, gates and unloading
Look at the box seams for rust holes and cracks, and see that the gate slides freely and shuts tight. A leaking gate loses grain and a gate that sticks tempts someone to climb into the wagon. The rule is the same as on other grain machinery: stay out of flowing grain, and do not step inside to clear a bridge. The CDC NIOSH grain handling page lists the hazards.
Check lights and the slow moving vehicle emblem if the wagon goes on a road, and see the lighting and SMV emblem inspection form.
Parts and salvage
Keep grease, spare bolts, hub dust caps and a pair of bearing sets for your wagon type on hand, and write down the make and model of the running gear because many gears are interchangeable only within a model range. Salvage yards often have axles, running gears and tongues at fair terms. Check castings and welds for cracks, measure the pin sizes, and check the bearing fit. Buy new for brake parts, safety chains and hitch pins.
A wagon that stays on the farm may get less attention than one on the road. Treat it the same. Do it once a year, before harvest, and note it down so you will know what shape it is in.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: CDC NIOSH Grain Handling · OSHA Agriculture · Iowa State Extension