Parts & Salvage Directory

Combine Harvest Preparation Checklist

Harvest preparation starts the week the last field is cut, not a week before the next one. The combine is a long list of belts, chains, bearings and sensors, and the parts that will fail in October are usually visible in the shop in the off-season.

Look at the machine while it is still clean

After last season's cleaning, go over it slowly with a flashlight and a notebook. Look for:

  • Cracked or worn feeder house chains, slats and drive components.
  • Rotor or cylinder bars, concaves and straw walkers or sieves for wear, bends and missing hardware.
  • Bearings with play, rough turning or old, dried grease.
  • Belts that are cracked, glazed or have uneven wear. Belts of worn variable-speed sheaves also fail.
  • Hydraulic hoses with chafing or seeping fittings.
  • Wiring harness damage, especially where mice have been.

The shop manual or the dealer's service tech can tell you the inspection points for your model.

Order parts while there is time

Make a list from your notes, including part numbers and the machine's serial number from the plate, so the parts counter can confirm fit by model year range. Parts that are commonly used up in a season include belts, chains, knife sections, bearings, filters and key sensors. Ordering now beats waiting on a backordered part in the middle of corn harvest. A salvage part can be a sensible choice for sheet metal, covers and non-critical brackets, but check casting cracks and wear before buying and confirm serial number ranges match, because mid-year design changes are common. Buy new for shields, brake parts, steering and safety-critical hydraulics.

Calibrate and test

Before the field work, run the machine at stationary speeds with everyone clear. Listen for unusual noises. Many monitors and yield systems need calibration for each crop: follow the operator's manual and your dealer's guidance. Check the header on the ground with the combine header maintenance record in hand, and the daily routine in the combine daily inspection and cleaning checklist.

Safety before the first pass

Review lockout, shield and fire practices with everyone who will run or ride along. Replace any missing shields before the first pass. Make sure fire extinguishers are charged and the cab has a working exit and rear-view mirrors. Keep clear of overhead lines when raising unloading augers. For general guidance on grain and harvest hazards, review NIOSH grain handling resources.

A short plan that works

Many operators write a one-page plan in order: parts ordered, service done, calibration done, test run done, spares loaded. Cross off each item and file the page with the machine's records so the next year's list is easier to build. That way you start harvest with fewer surprises, and your dealer knows what to expect.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: CDC NIOSH Grain Handling · OSHA Agriculture