Combine Daily Inspection & Cleaning Checklist
The combine that runs through the whole harvest is almost always the one that gets blown off, greased and looked over every single day. Downtime in October costs more than any part, and the checks below take less time than one breakdown.
First thing in the morning
Park on level ground, shut it down and take the key. Walk around before you climb in.
- Look under the machine for fresh drips: engine oil, hydraulic fluid, coolant, fuel. A new puddle tells you where to look.
- Check engine oil, coolant and hydraulic reservoir levels per the operator's manual. Low hydraulic oil often means a leaking hose or fitting, not a normal use.
- Check the radiator screen and cooler intake. A plugged screen overheats the engine fast, especially in dusty corn.
- Grease all fittings called out for daily service. The manual's lubrication chart shows the spots and the lube type.
- Look at belts and chains: belts for glazing, cracks and fraying, chains for slack and dry links. Drive belts that squeal at start-up are slipping.
- Look over the feeder house, rotor or cylinder and concave areas for stuck debris, wrapped twine or loose hardware.
The cleaning that prevents fires
Dry crop residue and dust collect around the engine, exhaust, bearings and belts. A small hot bearing or exhaust surface can ignite it. Blow off or sweep the engine compartment, radiator, exhaust area, bearings and drive belts at the intervals your conditions demand: dusty, dry harvest means more often, sometimes several times a day. Wrapped crop around a shaft or bearing generates heat that you can smell before you see it. Keep a charged, rated fire extinguisher in the cab and another on the ground, and carry a phone.
End-of-day routine
Before you leave the field, idle the machine a few minutes, then shut it down. Walk the machine again, feeling bearings with the back of a gloved hand, carefully, once they have had time to cool a little. A bearing noticeably hotter than its neighbors is on its way out. Clean out the grain tank auger area and sweep out the cab. Make notes on anything you saw: odd noises, slipping belts, a header height sensor acting up.
When to stop
Always lock out the machine, remove the key and wait for all moving parts to stop before reaching into the unit, as in OSHA's lockout guidance. Never clear a plug with the engine running. Call the dealer for anything involving the rotor, drive variators or high-pressure hydraulics.
Parts notes
Write each worn item with the part number, belt or chain size and machine serial number. Bearings, belts, chain sections, knives, and guards are the stuff worth stocking before harvest. Used parts can make sense for non-wearing items such as covers or sheet metal, but buy new for belts, shields, brake components and anything that guards you from rotating shafts. For harvest planning, see the combine harvest preparation checklist and keep an eye on header care as well.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Lockout/Tagout · OSHA Agriculture