Parts & Salvage Directory

Square Baler Maintenance Log

A square baler is a very busy machine. A plunger slams back and forth many times a minute, needles swing through the bale chamber, and knotters tie twine in a split second. Everything is under load, and things loosen and wear in a pattern that experienced balers learn to read. Keeping a short log of what you did, and what you replaced, lets you see that pattern for yourself.

Where the wear shows up first

The plunger and its bearings do the heavy work. Check the plunger rails and bearings for wear, and look for scoring or bright spots where parts rub. The flywheel and drive line carry big loads too, so make sure shields are in place, and look for cracked or bent parts. A shear bolt or slip clutch protects the drive; replace a shear bolt with the exact grade the manual calls for. Do not use a stronger bolt, because that moves the failure somewhere more expensive.

The knife and bale chamber matter next. A dull or chipped knife makes ragged bales and slows the plunger. Check the stripper plates and chamber for rough spots where hay hangs up.

Needles and knotters

Most missed bales come down to the twine and knotter. If you are having trouble, check the baler knotter troubleshooting guide before you start adjusting. In short, look at the twine path, the tension, the needles and the knotter parts for wear and dirt. Never reach into the chamber or near the needles with the machine running, and make sure the plunger and needles are blocked or locked out as the manual requires before working on them. Stored energy from the needle drive can still move a part.

What to write down each season

A baler log does not need to be long. Note the bales or hours at each service, the grease points done, the chain and belt condition, parts replaced with their numbers, and any odd noises. Over time you will see which parts last. Hay moisture and dust matter, so also record where you baled and what the conditions were.

  1. Grease all fittings on the schedule in the manual.
  2. Check chain tension and drive belts.
  3. Inspect knotter, needles, knife and twine path.
  4. Check tires, wheel bearings and hitch.
  5. Test lights and the SMV emblem for road travel.

Our hay equipment maintenance calendar can help you plan the timing.

Parts and salvage

Stock extra shear bolts, knotter parts, needles, twine discs and bearings, plus a few chain links. Note the part numbers from the parts catalog with the baler model and serial number. Used knotter or plunger parts can be fine if they match your model and are not worn or cracked, since baler designs change across years. Buy new for shields, drive-line parts and safety chains. If the plunger knocks, the gearbox leaks heavily or the frame is cracked, call a dealer.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Lockout/Tagout · OSHA Agriculture · Cooperative Extension (eXtension)