Parts & Salvage Directory

Auger Post Driver Maintenance Log

A post driver or auger attachment is a hard-working tool that takes a beating on rocks and roots, and it is usually ignored until a hose blows in the middle of a fence row. A few regular checks keep it earning its place on the loader or skid steer.

Pins, mounts and the frame

The driver or auger hangs on a quick-attach plate or a three-point mount, and the pins and bushings take shock every time it drops. Look at the pins for wear steps and the holes for stretched ovals. A loose mount makes everything else wear faster and can let the attachment shift under load. Check welds on the frame and the mast for fine cracks, especially around the mounting ears and the base of the mast. Cracks usually start as a thin dark line with rust at the end.

If the attachment uses a locking handle or wedge system, make sure both locks fully seat every time you hook up. Look behind the machine as you lift to confirm the attachment is truly pinned.

Hydraulics

Hoses are the first thing to fail on an attachment because they flex and rub. Look for rubbed spots, bulges, and weeping fittings. Replace any hose with an exposed wire layer. Make sure couplers are clean, caps are on when not connected, and the hose routing does not pinch when the mast tilts. Never feel for a leak with your hand. Pressurized fluid can pierce skin, and the hydraulic injection first aid guide explains why that is an emergency.

Keep an eye on the hydraulic motor on an auger. Whining, a hot case or slow speed under load can mean low flow from the carrier machine or a worn motor. Check the carrier's hydraulic flow and pressure against the attachment's manual rather than guessing.

Bits, teeth and gearbox

On an auger, look at the bit and the teeth. Teeth that are rounded or missing make the machine push harder and cook the gearbox. Replace teeth in sets where the manual says to, and make sure the retaining pins and clips are seated. Look at the auger flighting for bends, and at the drive hub for play.

For a planetary gearbox, check the oil level per the manual and the plug for metal flakes. Seeps at the output seal mean dirt will soon follow. On a post driver, check the striking face and the guide for wear, and look at the cylinder rod for scoring.

What to log and what to buy used

Keep a small log with the date, the carrier machine, the problem and the part numbers you replaced. Note the model, serial and the hydraulic motor tag, so you can match parts later. When teeth or hoses are the only parts that wear, a log shows you how often they actually go and helps you stock the right spares.

Used parts can be a good deal for mast sections, plates and some motors, if the casting has no cracks and the splines are not chewed. Buy hoses, pins and gearbox seals new. If you need a local salvage yard or dealer, look in the state directory. For related checks, see the pallet fork inspection checklist and the front-end loader safety inspection.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Agriculture · Extension.org