Parts & Salvage Directory

Disc Harrow Maintenance Log

A disc harrow looks simple, and that is why it gets neglected. But the bearings run in dirt all day, the blades get dull and out of round, and the gang bolt is under constant load. A little attention each season keeps it pulling easily and saves fuel.

Where the wear shows up

Start with the blades. Dull or chipped disc blades ride up instead of biting, and you will see it as a rougher, shallower pass. Look for cracks starting at the edge, especially near the notches on notched blades, and for blades that have worn smaller than their neighbors. A blade that has lost its edge unevenly on one gang will pull the whole machine sideways.

Next, check each gang:

  • Spin the gang by hand with the disc raised and blocked. Roughness, wobble or noise points to a bearing failing.
  • Check the gang bolt and spools. A loose gang bolt lets blades slip on the shaft, wallows the square holes in the blades and ruins the whole gang. Retighten to the manual's specification, and look for a bolt that has stretched.
  • Look at the bearing housings for grease leaking from seals, cracked mounts and loose bolts.
  • Check the scrapers where fitted. Worn or bent scrapers let mud pack between blades.

Frame, hitch and wheels

Walk the frame and look at weld areas near the gang hangers and the hitch for hairline cracks. Check the pins, clevises and hydraulic hoses on wing folds, and the transport wheels and tires. Transport locks must engage fully. A wing that drifts down on the road is a serious hazard, so replace worn pins and cylinders, and never travel without the locks in place. For hitch work see the implement hitch and safety chain inspection, and for tires and bearings the wheel bearing repack record.

What to write down

Record the make, model and serial number, the blade size and style (plain or notched), the number of blades per gang and the bearing numbers. Photograph the data plate. That is what a parts counter needs, and without it you will likely buy the wrong blades or bearings.

Buying new versus salvage

Blades and bearings are wear items worth buying new in matched sets. A used gang from a salvage yard can be a fair buy for an older disc, if the gang diameter, spacing and bearing style match; check the shaft for straightness and the blades for cracks, and be wary of a gang that has been welded on. Hitch parts, transport locks and hoses should be new.

Safety

Block the frame before working under it, and never stand near a raised wing. Never ride on the disc or the drawbar. Review ASABE safety resources for general machinery practice.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: ASABE · OSHA Agriculture