Farm Equipment Winterization Checklist
Winter is when equipment either rests well or quietly deteriorates. Water in the fuel, a weak coolant mix, a battery that froze, and a family of mice in the air cleaner are all things that show up in April as a long list of repairs. Most of it is avoidable with a day of work per machine in the fall.
Clean and fix before you park it
Wash the machine and let it dry. Dirt holds moisture against metal, and crop residue feeds rodents. While it is clean, you can see leaks, cracks and worn parts. Fix them now, when the dealer is not swamped, and order parts for the winter. Put your list in the machinery repair log so it carries into spring.
Grease every fitting per the manual, and run the machine to move fresh grease through the joints. Touch up bare paint or rust spots.
Fluids
- Coolant. Test the freeze protection of the mix with a hydrometer or test strips, and top up with the type specified in the manual. Do not mix different coolant types. If the coolant is old, ask your dealer when to replace it.
- Engine oil. Many operators change oil and filter before storage so acids and moisture from used oil do not sit in the engine. Follow the manual's guidance.
- Fuel. A full tank leaves less room for condensation. Diesel in storage can pick up water and microbial growth, so some farms use a fuel treatment suited to storage. Choose products and doses per the label and engine maker. Drain water from separators.
- Hydraulic and transmission fluid. Check levels and condition. Milky fluid points to water and needs attention from a pro.
Batteries
Cold weakens batteries, and a discharged one can freeze and crack. Clean the terminals, charge fully, and either disconnect or store them in a place that stays above freezing but off a damp concrete floor. Check the charge once in a while through the winter. See the battery maintenance and testing log.
Tires, hitches and moving parts
Check tire pressure cold, per the manual or tire sidewall data. For long storage, many owners get weight off the tires by blocking up the frame, but only do this safely with proper stands rated for the load, never with just a jack. Release tension on belts if the manual says so, and lower implements to the ground, or support them on blocks. Cover exposed hydraulic cylinder rods with a protective coating, or retract cylinders when possible.
Keep pests out
Plug exhaust and air intake openings with something obvious, like a bright rag with a tag, so you remember to remove it. Check cab floors, wiring harnesses and insulation for nests. Mouse damage to wiring is among the more expensive spring surprises. Keep feed and grain away from stored equipment.
Spring wake-up
Remove the plugs, check fluids, test the battery, and look for leaks before starting. Then run through the spring equipment ready checklist. If a part needs replacing, record the model and serial number and check the state directory for a dealer or salvage yard that carries it.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: Extension Foundation · ASABE