Parts & Salvage Directory

Battery Maintenance & Testing Log

Most no-start calls in spring are battery problems, and most battery problems are preventable. A battery that sat all winter, a loose cable or a dirty terminal can look like a dead starter. Check the simple things before replacing anything expensive.

What a battery tells you

Start with a visual look. Check the case for cracks, bulges and wet spots. A swollen case means the battery has been overcharged or frozen and should be replaced. Look at the terminals for white or blue-green corrosion, which adds resistance and starves the starter. Clean terminals with a battery brush and a baking soda and water mix, rinse carefully and dry them, then reconnect the cables snugly, positive first and negative last. Coating the terminals lightly afterward slows corrosion.

Then look at the hold-down. A loose battery vibrates, and vibration kills plates. Make sure the hold-down is tight and not cracked, and check the tray for rust.

Testing, not guessing

A voltmeter on a rested battery gives a rough read of its charge, and the battery maker's chart tells you what the numbers mean. Voltage alone does not tell you whether it will crank a cold diesel. For that you need a load test, which many parts stores and dealers will do for free. A battery that tests at a good charge but drops fast under load is on its way out.

Do not forget the cables. Wiggle each end and feel for warmth after cranking. A hot cable end or a battery post that gets hot is a sign of a poor connection. Look for corroded or frayed cables, and check the ground strap where it bolts to the frame, since a rusty ground makes a good battery act dead. The electrical system troubleshooting worksheet shows how to trace this kind of fault.

If the machine sits for months, use a maintenance charger or disconnect the battery. Charge slowly and in a ventilated place.

Safe handling

Batteries give off hydrogen gas, so keep sparks, flames and cigarettes away. Wear eye protection and gloves, because the acid burns. Remove rings and watches before working near terminals, since a wrench across the posts can weld a tool in an instant. Never jump a frozen battery. Lift with care because they are heavy. Read the equipment fire response procedure so everyone knows what to do if something does ignite.

Replacing and recording

When it is time to replace, match the group size, terminal position and the cold cranking rating the operator's manual lists. Do not assume a battery that fits the tray is right. Tractors with two batteries need matched units. Note the date you installed each battery, and write it on the case with a marker, so you know how old it is next fall.

Used batteries are rarely a bargain, since age is hard to judge. Cables, trays, hold-downs and terminals from a salvage yard can be worth buying if they are clean and match your machine. Look for local suppliers in the state directory if you need them. For routine upkeep, the tractor 50-hour maintenance log is a handy companion.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: Extension.org · OSHA Agriculture