Parts & Salvage Directory

Irrigation Pump Maintenance Log

Pumps usually give warnings before they fail. The trouble is that those warnings are subtle, such as a slightly different sound, a bit more vibration, or a seal that drips a little faster. A short log makes the change obvious.

What to check and note

On each visit, walk around the pump with the system running. Listen for gravel-like rattling, which suggests cavitation, and for a grinding or high whine from the bearings. Place a hand on the bearing housing, with the guards in place and clear of rotating parts, and note whether it feels hotter than usual. Look at the shaft seal or packing: a slow drip is often normal for packing, a stream or spray is not, and a mechanical seal that weeps steadily is on its way out. Check the pump base and coupling for loose bolts, and check any belts or shafts for guards.

Note pressure and flow readings from your gauges and compare them with past entries. Falling pressure at the same engine speed can mean a worn impeller, a leaking suction line, or a clogged strainer. Pull values for normal operation from the pump data plate and the manufacturer's curve, not from guesses.

Reading the symptoms

  • Pump loses prime or surges: look for air leaks in suction fittings and low water level at the intake.
  • Noise like marbles: check for restricted suction, a plugged screen, or an intake too close to the water surface.
  • Hot bearing: check grease type and amount per the manual, since too much can cause overheating as well as too little.
  • Vibration: check alignment, a damaged impeller, or a bent shaft. Do not run a badly vibrating pump.
  • Reduced output: inspect the impeller and wear ring clearances per the service manual.

Records and parts

Keep the model and serial from the pump plate in the log, plus the part numbers for seals, bearings, gaskets, and the impeller from the parts catalog. When a part comes out, write down how it wore: grooved shaft sleeves or pitted impellers tell you about the water. If you buy a used impeller, casing, or shaft from a salvage source, check for cracks, pitting, and wear and match it to the exact pump model and size. Seals and bearings are cheap and are better bought new. The state directory can help locate suppliers.

Pumps connect to engines and to other plumbing, so see also the irrigation engine service log and the center pivot inspection checklist.

Shut down and lock out the power before touching a coupling or seal, as OSHA lockout guidance describes. If you find electrical issues, call a qualified electrician.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Lockout/Tagout · Extension · ASABE