Parts & Salvage Directory

Irrigation Engine Service Log

An irrigation engine works differently from a tractor engine. It may sit idle for months, then run for days at a steady load with nobody beside it. That pattern wears it in particular ways, and a simple log catches problems before a dry August turns them into emergencies.

What to write down every time

Record the date, hours from the hour meter, and what you did. At each start, note the oil level and color, coolant level, belts, and any leaks at the pump drive. Write down gauge readings at normal running speed: oil pressure, coolant temperature, and the engine speed the system runs at. Do not copy numbers from this article; take the right values from the engine manual. What matters is whether this season looks like last season. A slow drift in oil pressure or temperature is the signal.

Keep fuel notes too. Water in fuel and algae in a tank that sat all winter cause hard starts and clogged filters. Note when you drained the water separator and changed filters.

Service work and how often

Intervals come from the engine manual, and they are usually counted in hours. Mark the next due hour reading on the log so it is obvious when you are close. Typical jobs include engine oil and filter, fuel filters, air cleaner service, coolant checks, belt replacement, and checking the drive between engine and pump. For the oil change routine, the engine oil and filter change tracker covers the basics. Use the oil grade specified in the manual.

Watch the cooling system closely, since a plugged radiator screen or a loose fan belt on a long run overheats the engine, and these engines often run in dusty or chaff-heavy conditions. Clean the screen, and look at hoses for soft spots.

Before the season

Do a dry run before you need water: check the battery and cables (see the battery maintenance and testing log), the fuel system, the safety shutdowns, and the guards over belts and shafts. Shutdown switches for low oil pressure and high temperature protect the engine only if they work, so test them as the manual describes. Replace damaged shields and guards.

Parts to have on hand

A spare set of filters, belts, and the gasket or seal that your engine tends to leak are cheap insurance. Record the part numbers from the parts catalog in the log next to the engine model and serial number. For used engine parts from a salvage yard, match the engine serial range, and inspect for cracks, scored surfaces, and damage to threads. Fuel lines, hoses, and guards are best bought new.

For safe servicing, lock out the engine and pump before reaching in, as described by OSHA.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Lockout/Tagout · ASABE · Extension