TMR Mixer Maintenance Record
A TMR mixer works harder than almost any machine on a dairy or feedlot. It turns every day, handles wet, heavy feed and sits in the weather. When it fails, the cows still need to eat, so the best maintenance is the kind that happens on a quiet afternoon rather than in the feed alley at five in the morning.
Knives and augers tell you how the ration is mixing
Watch the mixer when it is running. If long hay is not getting chopped, or the ration comes out stringy on one end, the knives are probably dull or worn short. Shut down, lock out the drive and look at the knife edges from inside the box. Dull knives raise horsepower draw and mixing time and burn fuel. Replace knives in sets as the manufacturer directs, since mixing a worn knife with a fresh one makes the load uneven.
Check the auger flighting for thinning edges and for bent or cracked sections. Hard-faced edges wear down slowly, and once the hard surface is gone the steel goes quickly. Also look at the bolts that hold knives and wear plates for stretch or missing hardware.
Drive, gearbox and chains
Look at the gearbox oil level and the color. Milky oil means water has got in through a seal. Dark and gritty oil means wear. Use the oil type shown on the gearbox tag or in the manual. On PTO machines inspect the driveline shields and the slip clutch, as covered in the PTO safety and shield inspection. On a chain-driven unit, look for stiff links, dry spots and sprockets with hooked teeth.
Scales, hydraulics and the discharge door
Feed accuracy depends on the scale. If the readout drifts or the load cells sit in mud, clean around the mounts and check the cables for cuts where they flex. Do not recalibrate by guess; follow the indicator maker's procedure. Check the discharge door cylinder, hoses and the door seals. A leaking door wastes feed.
What to write down
Keep a notebook or page in the shop with the date, hours or loads, what was changed, and the part numbers of knives, bearings, seals and chains. Write the mixer model and serial number on the first page, because manufacturers often change parts mid-production. A short record lets you see that knives lasted a certain number of loads last time and spot trouble early. The machinery repair log is a good companion for the larger jobs.
Salvage versus new
Salvage works for shields, frame brackets, door hardware and some sprockets, as long as the casting is not cracked and the hole spacing matches your serial range. Buy new for knives, bearings, gearbox seals, load cells and anything on the hydraulic circuit. A used hose may fail from the inside without showing a mark. Look for local yards through the state directory.
Shut down and lock out before opening any inspection hatch or climbing in, because an auger can turn from stored energy or from someone starting the tractor. See OSHA lockout and tagout and, for hearing and noise, NIOSH noise guidance. When the gearbox or a big bearing is the problem, call the dealer rather than guessing.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Lockout/Tagout · CDC NIOSH Noise