Parts & Salvage Directory

Sprayer Nozzle Wear & Calibration Record

A sprayer can look fine and still be putting on the wrong rate. Nozzle tips wear from the inside, so the opening slowly gets bigger, and a boom with some worn tips and some new ones applies unevenly. You see it as streaks, as areas with poor control and as a tank that empties faster than it should. The fix is cheap compared to the chemical, which is why a yearly nozzle check pays for itself.

Why wear matters more than it looks

Abrasive materials such as wettable powders, some fertilizers and even dirt in the tank water scour the orifice. As it opens up, the nozzle delivers more at the same pressure and the spray pattern changes. A single nozzle that is badly worn can run noticeably over the rest, and you will not see it from the cab. Cracked or damaged tips and clogged screens make the problem worse by throwing the pattern off in the other direction.

A simple output check

Do this with clean water, not chemical, and with the sprayer parked and following the safety directions in the operator's manual.

  1. Clean or replace the strainers and screens first, so you are testing the nozzle and not a plug.
  2. Run the sprayer at the working pressure your manual or the nozzle chart lists.
  3. Catch the flow from each nozzle in a measuring container for the same length of time and compare the readings.
  4. Mark any nozzle that is out of line with the group, and replace it. Many guides suggest replacing tips that are a noticeable amount off the average; check your nozzle manufacturer's chart or your Extension office for the number to use.

Also compare the sprayer's flow meter and pressure gauge to your catch readings. A faulty gauge can lead you to set the wrong pressure for the whole season.

What to write down

Keep a simple record per sprayer: the tip type and size you use, the date installed, the acres or hours they ran, the catch results and the pressure used. That record tells you when to replace tips before they drift, and it helps with calibration when you change products or speed. Check your travel speed with a measured distance, because ground speed is half the calibration. The tractor operation log is a convenient place to note hours.

Parts to keep on hand

Carry spare tips of every size you run, spare screens, gaskets and diaphragm kits for the pump, and a couple of hoses and clamps. Note the part numbers and the nozzle manufacturer's code. Do not mix tip types on a boom. Used pumps and booms can work, but check valves and hoses for age. Buy new chemical-handling hoses, seals and anything on the pressure side, since failures put spray on you.

Wear gloves, eye protection and other personal protective equipment listed on the product label when you handle the chemical, and rinse the sprayer in a way that follows the label. The EPA pesticide pages are a good place to read up on rules. Also see rotary hoe maintenance if you work ground before spraying.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: EPA Pesticides · Cooperative Extension (eXtension) · ASABE