Silo Unloader Inspection Form
A silo unloader works in a place most people never see: the inside of a tall structure, with the feed above it and a mechanical cutter underneath. Because of that, problems often show up as a change in how the machine sounds or how the feed comes out rather than something you can walk up and look at. Doing a short inspection before each feeding season, and a quick look every week or two during it, catches most trouble early.
Before anyone goes near it
An unloader is a machine, but a silo is also a confined space, and that is the larger danger. Fermenting silage can leave gases that are not safe to breathe, and an unloader that sits in a tower has people working on it who sometimes ignore that. Do not enter a silo to repair an unloader unless you have followed the safety guidance for confined spaces, which means ventilation, a second person outside and a way to get you out. See the OSHA agriculture page for where to start. If you are unsure, call a dealer who does this work routinely.
Lock out the power at the disconnect before touching anything. A tower unloader can start without warning if someone flips a switch at the controls.
What to look at, in order
- Cable or chain and winch. A top unloader hangs on a cable or chain. Look for broken strands, kinks, rust and bright wear spots. Replace a cable that looks questionable; this is the part holding the machine up.
- Cutter and auger. Inspect the cutter teeth or chain for dullness and cracks. Worn teeth lead to slow unloading and uneven feed.
- Drive and gearbox. Check for oil leaks and for play when you push on the drive shaft. Follow the manual for the correct oil type and level.
- Discharge chute and door. Make sure the chute swings freely and the door seals, so feed does not fall behind.
- Wiring and controls. Look for chafed cables where they run up the silo, and for a limit switch that no longer shuts the machine off when it should.
Symptoms that point to the cause
A loud grind from the cutter often means a loose tooth or a bearing starting to go, so shut it down and look. Feed that comes out in chunks instead of a steady stream usually means dull teeth or a plugged chute. A cable that creaks or lets the unit tilt means a pulley or winch is binding. A machine that stalls under load can have a worn gearbox or a weak electrical supply, so check your wiring before blaming the unit.
Parts and salvage
Silo unloaders are old designs, and many parts are only available used. When buying a salvage gearbox or motor, check that it turns freely by hand, has no cracks in the housing, and matches the model and serial range. Keep the part number and model information in your parts inventory tracking sheet. Safety items such as cables, limit switches and guards are not worth buying used. Pair this inspection with the auger and conveyor inspection record if you feed with conveyors as well.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Agriculture · OSHA Lockout/Tagout · CDC NIOSH Agriculture