Parts & Salvage Directory

Silage Harvest Equipment Checklist

Silage season is short and unforgiving. Corn gets too dry or the forage gets rained on, and a chopper that sits for a day waiting on a part throws the whole crew off. Most of what goes wrong in a silage crew is predictable, so the work to do ahead of time is mostly a matter of going through each machine in the line and asking what wears and what it would take to replace it.

Start with the chopper

The forage harvester does the hardest work in the line. With the machine locked out and the key out, look at the knives and the shear bar. Dull knives or a shear bar with a rounded edge show up later as ragged, long-cut forage and a fuel bill that creeps up. Check the knife mounting hardware for stretched or battered bolts, and replace anything questionable rather than reusing it. Follow the operator's manual for knife sharpening and shear bar adjustment, because the method and the gap differ by model.

If the machine has a kernel processor, look at the roll surfaces for wear and chipping, and turn the rolls by hand to feel for rough bearings. Spin the feed rolls and check the metal detector, if fitted, since a stray piece of wire or a tooth from a rake can wreck a cutterhead.

The rest of the line

Haul units and the packing tractor get less attention than the chopper, but they cause plenty of delays.

  • Wagons and trucks: check tires, brakes and lights, and the floor or sides for cracks. Drive-over loads on a bumpy field punish old welds.
  • Hitches and safety chains: look for worn pins and cracked clevises before pulling a loaded wagon. Our guide on hitch and safety chain inspection covers what to look for.
  • Packing tractor: heavier is better for packing, but only if the brakes, tires and ROPS are in good shape. Review the tractor ballast and weighting guide before adding weight.

Parts worth having on the shelf

A silage crew cannot wait for a mail-order part. Make a short list of the wear items that stop the line: knives and their bolts, shear bar hardware, drive belts, a spare bearing or two for the feed rolls, hydraulic hoses and fittings for the spout and header, and bulbs and fuses. Record the part numbers from the parts catalog and the machine's model and serial number so a dealer can match them over the phone. If a used or salvage part is the only way to get a discontinued item, check it carefully for cracks and wear, and make sure it matches your serial range. Do not substitute used guards, shields or hydraulic hoses on a safety-critical spot. Buy those new. The state directory can help you find parts counters and salvage yards near you before the rush.

Safety on the pad

Stay clear of the packing area when tractors are working, and never let anyone ride on a wagon, hitch or the back of a tractor. Never clear a plugged spout or feed roll with the machine running. Shut down, wait for everything to stop, and lock out the power as described by OSHA on lockout and tagout. Also keep a charged extinguisher on the chopper, since dust and chaff pile up around hot bearings and exhaust.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Lockout/Tagout · OSHA Agriculture · ASABE