Air Seeder Cart Inspection Form
An air seeder cart fails in boring ways. A cracked hose, a worn meter roller or a tired fan bearing will cost a day in the field, and almost all of it shows up during a slow walk-around in the shop. Do that walk-around a few weeks before seeding, while the parts counter still has time to get what you need.
Start with the air side
The fan is the heart of the system. Run it with the guards on and listen. A steady hum is fine. A growl or a rhythmic tick points to a bearing or a bent blade. Check the hydraulic motor and its hoses for weeping at the fittings, and look at the fan housing for product dust, which tells you where air has been leaking.
Next, follow every distribution hose from the cart to the openers. Flex each one along its length. Hoses usually fail at the bends and at the clamps, going soft, cracked or flattened inside. A hose that looks fine outside can still be scored inside by product, so pinch-test for thin spots. Replace clamps that have lost their spring, and make sure no hose rubs a frame edge.
Meters, seals and tank
Pull the access covers on the metering section and turn the drive by hand. Rollers should turn smoothly, and the flutes or cells should be clean and sharp. Chipped or rounded cells, a roller that has crept sideways on its shaft, or gaps at the housing wall mean uneven rates and are worth fixing before calibration. A calibration test only means something if the meter is in good shape.
Look at the tank lid seals and the tank floor. A tank has to hold air pressure, so a seal that has flattened or split will bleed pressure and blow product out around the lid. Check ladders, the lid latch and the tank for rust-through at welds. Treated seed leaves a residue that is rough on rubber and steel, so wash out the tank and let it dry before storage.
Running gear
Look at the tires for cracks, bulges and uneven wear, and check pressure cold against the number in the operator's manual. A loaded cart is heavy, so a tire that is a little low carries a big penalty. Grease every fitting the manual lists, and check wheel bearing play by rocking the wheel. Look over the hitch pin, the safety chain and the brake or hydraulic lines if your cart has them. The implement hitch and safety chain inspection covers what to look for there.
Buying parts for it
Write down the cart model and serial number, the fan motor tag and the meter roller part numbers before you shop. Roller and housing parts change between model years, so match the serial range in the parts catalog, not just the model name. A used fan motor or meter housing from a salvage yard can be a sound buy if the shaft is straight, the casting has no cracks and the hydraulic ports are clean and match yours. Buy hoses, tires and anything that carries the cart on the road new. To find a salvage yard or dealer near you, start at the state directory.
Finish by checking the monitor and any shaft sensors for clean connectors and a signal at the display. A drive that quits mid-field with no alarm is a common and expensive surprise. For more on the electrical side, see the electrical system troubleshooting worksheet. Your state Extension office, reachable through Extension.org, can also help with calibration questions.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: Extension.org · OSHA Agriculture