Loader Bucket Wear Inspection Log
A loader bucket takes more abuse than almost anything on the farm, and the damage is rarely dramatic. The cutting edge wears flat, the bottom thins, the pins loosen, and one day a corner cracks. Looking at the bucket on a regular schedule catches this while it is still a bolt-on repair and not a weld shop job.
The cutting edge first
The bolt-on cutting edge is a wear item by design. Look at it from the side. A new edge has a defined bevel, and a worn one is rounded and shorter, with bolt heads close to the surface or already ground down. If the bolts are close to flush with the edge, replace it before you wear into the bucket floor, because the floor is the expensive part. Check that the edge is flat across its length; a bent edge points at hitting something hard at an angle.
Reversible edges can be flipped once, but only if the bolt holes line up and the other side is still sharp. When ordering, record the bucket width, the number of bolt holes and the manufacturer's part number off the bucket tag, because edges for the same-width bucket may not match another brand's hole pattern.
Floor, sides and welds
Drag a hand carefully along the underside, with the loader down and the machine shut off, and feel for thin spots. A bucket floor that rings dull when you tap it with a hammer is not the same as one that sounds solid. Look at the side plates and the back, and trace every weld with your eyes. Hairline cracks start at corners and where the sides meet the floor. A crack that is just forming can be welded by a good fabricator; one that has already run several inches needs more than a bead.
Pins, bushings and the quick-attach
Grab the bucket at the top and bottom, with the loader supported, and try to move it by hand. Slop at the pivot pins usually means worn bushings. Check the grease zerks for fresh grease; dry pins wear quickly. On a quick-attach bucket, the latch pins should engage fully and the bucket should sit tight with no rocking. A loose attachment is a safety problem as well as a wear one; see the front-end loader safety inspection for related checks.
When salvage makes sense
Cutting edges, bolts, pins and bushings are ordinary wear parts, so buy new and keep spares on the shelf. A salvage bucket can be a reasonable choice if it matches your loader's attachment style and the frame is not cracked or bent; check welds and pin bores for ovality before paying for it. Do not weld on a hydraulic cylinder mount or a lift arm without a qualified pro.
For related hardware on other attachments, see the grapple bucket maintenance record. Check your operator's manual for the correct grease and greasing points, and see OSHA's agriculture page for general safety rules around loaders.
What to write down
Keep a short note each season: edge condition, any cracks found, any pins replaced, and the part numbers used. That note is what saves you an hour on the phone next time.
General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.
Sources: OSHA Agriculture · ASABE