Parts & Salvage Directory

Box Blade & Scraper Inspection

A box blade or rear scraper blade is a simple tool, which is why people tend to run it until something falls off. The parts that wear are few and cheap to replace, but only if you catch them before they damage the main frame.

The cutting edge and shanks

The cutting edge does the work, and it wears from the bottom up. A blade that is rounded, nicked or worn to the point that the bolt heads are close to the ground will pull poorly and leave a ridge. Flip a reversible edge if the other side is sharp, or replace it. Make sure the mounting bolts are tight and the heads are seated in their countersinks. A bolt head standing proud will wear off quickly.

If your box blade has scarifier shanks, look at the tips and the shank body. Tips are the sacrificial part. A shank that has been bent or has a crack near the mounting hole should be replaced rather than straightened, since a repaired crack tends to return. Check that the pins or bolts that hold them in are the right ones, not substitutes.

Frame, side plates and hitch

Walk around the frame. Look for cracks at the corners where the side plates meet the back, and for bends in the top link brace. Check the weld on the mast and the three-point pins. A bent mast leaves the machine hard to level and loads the tractor lift unevenly.

Hitch pins, lower link ends and the top link should show little wear. Elongated holes mean the pin is moving and wearing the tractor links too. The three-point hitch maintenance checklist covers the tractor side. Use the right category pins and retainers, and replace any pin that is worn or bent. A scraper that falls off a hitch on the road is dangerous.

If your blade has hydraulic tilt or angle, check cylinders for rod damage and hoses for rubbing. Be careful with pressure: a leak of fine spray can be dangerous, so use a piece of cardboard, not a hand, to find leaks.

Using it without damage

Watch how the machine is used as well as how it looks. Backing a box blade into a pile can bend the frame. Dropping it onto a rock in transport mode can too. Keep the tractor's rear weight in line with the manual, because a heavy implement raised high can make the tractor light in front. The tractor ballast weighting guide explains why.

Always lower the blade to the ground, shut the tractor off and take the key before working under or around it. Do not crawl under a raised blade held by the hydraulics alone. Use stands rated for the load.

Wear parts, new or salvage

Cutting edges and scarifier tips are wear items, so buy them new in the right hardness and size for your model. Note the make, model and the thickness of your edge before you order. Salvage frames, side plates and lift arms can be useful if they are straight and free of cracks, and if the pin spacing matches your tractor's category. When searching for a yard or dealer, the state directory is a good starting point.

Paint bare steel after a season to slow rust, and grease any pivot points the manual lists.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: Extension.org · OSHA Agriculture