Parts & Salvage Directory

ATV/UTV Farm Use Safety Inspection

Side-by-sides and four-wheelers do more daily work on most farms than any tractor, and they get the least attention. They also roll over in ways tractors do not. A short routine before the first ride of the day catches the things that hurt people.

The two-minute walk-around

Start at the tires. Check pressure cold, using the number on the vehicle placard or in the owner's manual, because these machines are sensitive to it and the numbers are low. Look for sidewall cuts and bead leaks. Uneven pressure side to side makes a vehicle pull and handle oddly on a slope.

Then check steering. Turn the bars or wheel lock to lock and feel for tight spots or slop. Look at tie rod ends and ball joints for torn boots and play; grab each wheel at the top and bottom and try to rock it. A wheel that clunks has a bearing or a joint on its way out.

Brakes next. Press the pedal or lever and note how it feels: it should be firm and come back by itself. A spongy pedal means air or a leak, and a grinding noise means pads are gone. Do not ride on a machine that you suspect of weak brakes. Fix it first.

Loads, hitches and passengers

Cargo beds and racks are rated for a limit that is on the vehicle or in the manual, and overloading raises the center of gravity. Keep the load low, centered and tied down. A sprayer tank or a bin of feed that can slosh is worse than a solid load. Check any trailer hitch for wear and a locked pin, and keep towed weight within the manual.

Ride only as many people as there are seats, and use the belts on a UTV. Riders on the cargo bed or on the back of a quad are an injury waiting for a bump. Youth riders should only operate machines sized for them, per the manufacturer's age guidance. The NIOSH agriculture pages have good material on youth and vehicle injuries.

Rollover protection and fluids

On a UTV, check the roll cage for bent tubes, cracked welds and loose mounting bolts. Make sure the seat belts latch and retract. Doors, nets and half-doors, if fitted, should close and keep arms inside. A cage that has been in a rollover should be inspected by a dealer, not just straightened.

Check engine oil, coolant and brake fluid against the manual, and look under the machine for drips. Look at the air filter, which clogs fast in dust and chaff, and at the CVT belt cover for dust or burnt smell. Check headlights, taillights and the kill switch.

Parts that are fine used, and parts that are not

Body panels, racks, seats and many mirrors are reasonable salvage buys. Match the model and year carefully, because frames and mounts change between years. Steering parts, brake components, belts, tires and anything in the roll cage should be bought new from a dealer or a reputable source. Keep a note of your VIN and model code so counter staff can match parts. To find a dealer or salvage yard near you, check the state directory.

For the rest of your equipment, the farm truck pre-trip inspection is a good model for a daily habit. Also see the tractor rollover prevention checklist, because many of the same slope rules apply.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: NIOSH Agriculture · OSHA Agriculture