Parts & Salvage Directory

Subsoiler Wear Inspection Form

A subsoiler works at the edge of what a tractor can pull. The shank rips through compacted ground, and the point and shin guard take most of the abrasion. When the wear parts go, the shank starts to wear instead, and a shank is much more expensive than a point. The idea of an inspection is simple: replace cheap parts on time so the costly ones stay intact.

Start with the point and the shin

Raise the tool on safe supports and block it so it cannot drop. Never work under a raised implement held only by hydraulics. Clean off the dirt so you can see the metal.

Look at each point. When the nose has rounded off or the tip has worn back, the shank is running with less penetration and more draft. This means more fuel and more strain on the tractor. A worn point also leaves the leading edge of the shank exposed. Check the shin guard or shank cover on the front edge for the same wear. Where hardfacing or a bolted shin is used, follow the maker's guide on when to replace it. Rotate or turn the parts only if the design allows it.

Shank, frame and hardware

  • Shank: look for cracks, particularly at the top near the frame and at the bend. Hairline cracks near a weld mean the shank can fail under load.
  • Shear bolt or trip: if your unit has a shear bolt or spring trip, check that the right bolt is in place and the spring is not weak or broken.
  • Frame and mounting: look for elongated holes, cracked welds and loose bolts. Retighten bolts to the torque in the manual.
  • Depth wheels and gauges: check bearings and the adjusting mechanism.

Write down the dates and what you replaced. If one shank wears faster than the others, check its position and spacing, because uneven wear can hint at a bent shank or a row with more load.

Reading what the wear tells you

Wear on the outside edge of a point can mean the shank is leaning, or the unit is not level. A point that wears quickly in sandy or rocky ground is normal, so adjust your schedule. Smooth, even wear suggests the setup is right. If the tractor struggles, look at the tractor ballast and weighting guide and your hitch, which the three-point hitch maintenance checklist covers.

Buying wear parts and salvage

Stock extra points, shin guards, bolts and nuts. Write down the part numbers and shank type, since points differ by model and serial range. A used shank or toolbar section can be a good buy if you check it for cracks, bends and worn holes, but a cracked or repaired shank is not safe to run behind a big tractor. Welding a cracked shank is a judgment call for a qualified welder, not a quick fix. Buy new for hitch pins, hydraulic hoses and lift pins. Do not weld on a frame unless you know the steel and the procedure.

General information only. Follow the operator's manual, your dealer's service guidance and the parts catalog for your specific machine.

Sources: OSHA Agriculture · ASABE · Cooperative Extension (eXtension)